The headlight leveling ECU assembly receives signals indicating the front right and front left wheel speed from the skid control ECU assembly using CAN communication.
| DTC No. | Detection Item | DTC Detecting Condition | Trouble Area | DTC Output from |
|---|---|---|---|---|
| B2415 | Vehicle Speed Sensor Malfunction | Malfunction in vehicle speed signal | ·
Headlight leveling ECU assembly ·
Skid control ECU assembly |
Headlight leveling ECU assembly |
Perform the communication function inspections in Diagnosis System to confirm that there are no CAN communication malfunctions before performing the following inspection.
Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>DIAGNOSIS SYSTEM
If the headlight leveling ECU assembly has been replaced, it is necessary to initialize the headlight leveling ECU assembly.
Click hereVehicle Exterior>LIGHTING (EXT)>AUTOMATIC HEADLIGHT BEAM LEVEL CONTROL SYSTEM>INITIALIZATION
Connect the GTS to the DLC3.
Turn the power switch on (IG).
Turn the GTS on.
Enter the following menus: Body Electrical / HL AutoLeveling / Trouble Codes.
Clear the DTCs.
| Proceed to |
|---|
| NEXT |
NEXT
Connect the GTS to the DLC3.
Turn the power switch on (IG).
Turn the GTS on.
Enter the following menus: Body Electrical / HL AutoLeveling / Trouble Codes.
Check for DTCs.
DTC B2415 is not output.
| Proceed to |
|---|
| OK |
| NG |
OK
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
NG