The headlight leveling ECU assembly stores this DTC if initialization has not been performed after the ECU was replaced.
| DTC No. | Detection Item | DTC Detecting Condition | Trouble Area | DTC Output from |
|---|---|---|---|---|
| B2450 | Initialization has not been Performed | Initialization of the headlight leveling ECU assembly has not been performed | Headlight leveling ECU assembly | Headlight leveling ECU assembly |
If the headlight leveling ECU assembly has been replaced, it is necessary to initialize the headlight leveling ECU assembly.
Click hereVehicle Exterior>LIGHTING (EXT)>AUTOMATIC HEADLIGHT BEAM LEVEL CONTROL SYSTEM>INITIALIZATION
Perform initialization of the headlight leveling ECU assembly.
Click hereVehicle Exterior>LIGHTING (EXT)>AUTOMATIC HEADLIGHT BEAM LEVEL CONTROL SYSTEM>INITIALIZATION
| Proceed to |
|---|
| NEXT |
NEXT
Connect the GTS to the DLC3.
Turn the power switch on (IG).
Turn the GTS on.
Enter the following menus: Body Electrical / HL AutoLeveling / Trouble Codes.
Clear the DTCs.
| Proceed to |
|---|
| NEXT |
NEXT
Connect the GTS to the DLC3.
Turn the power switch on (IG).
Turn the GTS on.
Enter the following menus: Body Electrical / HL AutoLeveling / Trouble Codes.
Check for DTCs.
DTC B2450 is not output.
If the headlight leveling ECU assembly stores DTC B2450 even though the ECU has been initialized, there may be a malfunction in the headlight leveling ECU assembly.
| Proceed to |
|---|
| OK |
| NG |
OK
NG