Home › Vehicle Exterior › LIGHTING (EXT) › AUTOMATIC HEADLIGHT BEAM LEVEL CONTROL SYSTEM › from 2019.07
RM2170E _59 Vehicle Exterior _057049 LIGHTING (EXT) _0278195 AUTOMATIC HEADLIGHT BEAM LEVEL CONTROL SYSTEM C

LIGHTING (EXT)  AUTOMATIC HEADLIGHT BEAM LEVEL CONTROL SYSTEM  B2451  Vehicle Specifications have not been Stored  


DESCRIPTION

The headlight leveling ECU assembly stores this DTC if the vehicle specifications have not been stored in the ECU.

DTC No. Detection Item DTC Detecting Condition Trouble Area DTC Output from
B2451 Vehicle Specifications have not been Stored Vehicle specifications have not been stored Headlight leveling ECU assembly Headlight leveling ECU assembly

CAUTION / NOTICE / HINT

NOTICE:

If the headlight leveling ECU assembly has been replaced, it is necessary to initialize the headlight leveling ECU assembly.

Click hereVehicle Exterior>LIGHTING (EXT)>AUTOMATIC HEADLIGHT BEAM LEVEL CONTROL SYSTEM>INITIALIZATION


PROCEDURE

1.SYNCHRONIZE VEHICLE INFORMATION
a.

Synchronize the vehicle information.


Result:
Proceed to
NEXT



NEXT

2.CLEAR DTC
2.CLEAR DTC
a.

Connect the GTS to the DLC3.


b.

Turn the power switch on (IG).


c.

Turn the GTS on.


d.

Enter the following menus: Body Electrical / HL AutoLeveling / Trouble Codes.


e.

Clear the DTCs.


Result:
Proceed to
NEXT



NEXT

3.CHECK FOR DTC
3.CHECK FOR DTC
a.

Connect the GTS to the DLC3.


b.

Turn the power switch on (IG).


c.

Turn the GTS on.


d.

Enter the following menus: Body Electrical / HL AutoLeveling / Trouble Codes.


e.

Check for DTCs.

OK:

DTC B2451 is not output.



Result:
Proceed to
OK
NG



OK

END (INITIALIZATION WAS NOT COMPLETED)

NG

REPLACE HEADLIGHT LEVELING ECU ASSEMBLY