These DTCs are stored when the CAN communication system is malfunctioning.
| DTC No. | Detection Item | DTC Detecting Condition | Trouble Area | DTC Output from |
|---|---|---|---|---|
| U0100 | Lost Communication with ECM / PCM "A" | Lost communication with hybrid vehicle control ECU | ·
CAN communication system ·
Hybrid vehicle control ECU |
Headlight leveling ECU assembly |
| U0129 | Lost Communication with Brake System Control Module | Lost communication with brake booster with master cylinder assembly (skid control ECU) | ·
CAN communication system ·
Brake booster with master cylinder assembly (skid control ECU) |
Headlight leveling ECU assembly |
| U0142 | Lost Communication with Body Control Module "B" | Lost communication with main body ECU (multiplex network body ECU) | ·
CAN communication system ·
Main body ECU (multiplex network body ECU) |
Headlight leveling ECU assembly |
Connect the GTS to the DLC3.
Turn the power switch on (IG).
Turn the GTS on.
Enter the following menus: Body Electrical / Main Body / Trouble Codes.
Clear the DTCs.
| Proceed to |
|---|
| NEXT |
NEXT
Connect the GTS to the DLC3.
Turn the power switch on (IG).
Wait 20 seconds or more.
Turn the GTS on.
Enter the following menus: Body Electrical / Main Body / Trouble Codes.
Check for DTCs.
DTCs are not output.
| Proceed to |
|---|
| OK |
| NG |
OK
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
NG
Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING