Home › Vehicle Exterior › LIGHTING (EXT) › AUTOMATIC HEADLIGHT BEAM LEVEL CONTROL SYSTEM › from 2019.07
RM2170E _59 Vehicle Exterior _057049 LIGHTING (EXT) _0278195 AUTOMATIC HEADLIGHT BEAM LEVEL CONTROL SYSTEM C

LIGHTING (EXT)  AUTOMATIC HEADLIGHT BEAM LEVEL CONTROL SYSTEM  U1000  CAN Communication Failure (Message Registry)  


DESCRIPTION

The headlight leveling ECU assembly stores this DTC if an internal error related to the CAN communication system is detected.

DTC No. Detection Item DTC Detecting Condition Trouble Area DTC Output from
U1000 CAN Communication Failure (Message Registry) CAN communication failure Headlight leveling ECU assembly Headlight leveling ECU assembly

CAUTION / NOTICE / HINT

NOTICE:

If the headlight leveling ECU assembly has been replaced, it is necessary to initialize the headlight leveling ECU assembly.

Click hereVehicle Exterior>LIGHTING (EXT)>AUTOMATIC HEADLIGHT BEAM LEVEL CONTROL SYSTEM>INITIALIZATION


PROCEDURE

1.CLEAR DTC
a.

Connect the GTS to the DLC3.


b.

Turn the power switch on (IG).


c.

Turn the GTS on.


d.

Enter the following menus: Body Electrical / Main Body / Trouble Codes.


e.

Clear the DTCs.


Result:
Proceed to
NEXT



NEXT

2.CHECK FOR DTC
2.CHECK FOR DTC
a.

Connect the GTS to the DLC3.


b.

Turn the power switch on (IG).


c.

Wait 20 seconds or more.


d.

Turn the GTS on.


e.

Enter the following menus: Body Electrical / Main Body / Trouble Codes.


f.

Check for DTCs.

OK:

DTCs are not output.



Result:
Proceed to
OK
NG



OK

NG

REPLACE HEADLIGHT LEVELING ECU ASSEMBLY