Home › Vehicle Interior › METER / GAUGE / DISPLAY › METER / GAUGE SYSTEM › from 2019.07
RM2170E _58 Vehicle Interior _057037 METER / GAUGE / DISPLAY _0278095 METER / GAUGE SYSTEM U

METER / GAUGE / DISPLAY  METER / GAUGE SYSTEM  DATA LIST / ACTIVE TEST  


DATA LIST


NOTICE:

In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.


HINT:

Using the GTS to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.


a.

Connect the GTS to the DLC3.


b.

Turn the ignition switch to ON (IG).


c.

Turn the GTS on.


d.

Enter the following menus:

i.

for Combination Meter: Body Electrical / Combination Meter / Data List.


ii.

for ABS/VSC/TRAC: Chassis / ABS/VSC/TRC / Data List.


iii.

for Engine and ECT: Powertrain / Engine and ECT / Data List.



e.

Read the Data List according to the display on the GTS.

Body Electrical / Combination Meter / Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note
Tail Relay SW Tail relay OFF or ON OFF: Taillight not illuminate -
ON: Taillight illuminate
Tail Cancel SW*1 Light control rheostat (Tail cancel switch) OFF or ON OFF: Tail cancel switch off -
OFF: Tail cancel switch on
ODO/TRIP Change SW Steering pad switch (Trip) OFF or ON OFF: Switch released -
ON: Switch pushed
P-Seatbelt Buckle SW*2 Front passenger seat belt buckle switch OFF or ON OFF: Front passenger seat belt fastened *A
ON: Front passenger seat belt unfastened
Vehicle Speed Meter Vehicle speed Min.: 0 km/h (0 mph), Max.: 255 km/h (158 mph) Almost the same as actual vehicle speed -
Engine Rpm Engine speed Min.: 0 rpm, Max.: 12750 rpm Almost the same as actual tachometer -
Coolant Temperature Engine coolant temperature Min.: 0°C (32°F), Max.: 127.5°C (261.5°F) After warming up: 75 to 100°C (167 to 212°F) -
+B Voltage Value Auxiliary battery voltage Min.: 0 V, Max.: 25.5 V 11 to 14 V -
Integrated Value for Maintenance Maintenance required reminder value Min.: 0 miles, Max.: 25500 miles Driving distance after performing maintenance required reminder reset procedure displayed Not applicable to this vehicle
Fuel Input Fuel input Min.: 0 L, Max.: 127.5 L Almost the same as actual fuel receiver gauge 10th segment illuminated: 31.7 to 36.0
9th segment illuminated: 28.5 to 31.7
8th segment illuminated: 25.4 to 28.5
7th segment illuminated: 22.1 to 25.4
6th segment illuminated: 19.2 to 22.1
5th segment illuminated: 16.2 to 19.2
4th segment illuminated: 12.7 to 16.2
3rd segment illuminated: 9.8 to 12.7
2nd segment illuminated: 6.9 to 9.8
1st segment illuminated: 5.0 to 6.9
Ambient Temperature Outside temperature Min.: -40°C (-40°F), Max.: 87.5°C (189.5°F) Almost the same as actual outside temperature *B
Rheostat Value*1 Light control rheostat value Min.: 0% (dark), Max.: 100% (bright) 0 to 100% -
HV System Indicator Hybrid system indicator value Min.: -101%, Max.: 511% -101 to 511% *C
Multi Switch (Up) Steering pad switch (Up) OFF or ON OFF: Switch released -
ON: Switch pushed
Multi Switch (Down) Steering pad switch (Down) OFF or ON OFF: Switch released -
ON: Switch pushed
Multi Switch (Enter) Steering pad switch (Enter) OFF or ON OFF: Switch released -
ON: Switch pushed
Multi Switch (Right) Steering pad switch (Right) OFF or ON OFF: Switch released -
ON: Switch pushed
Multi Switch (Left) Steering pad switch (Left) OFF or ON OFF: Switch released -
ON: Switch pushed
Oil Pressure Switch Engine oil pressure switch OFF or ON OFF: Engine started -
ON: Engine not started
Turn Signal Switch (Right) RH turn signal switch OFF or ON OFF: RH turn signal switch off -
ON: RH turn signal switch on
Turn Signal Switch (Left) LH turn signal switch OFF or ON OFF: LH turn signal switch off -
ON: LH turn signal switch on
Hazard Flasher Switch Hazard warning signal switch OFF or ON OFF: Switch released -
ON: Switch pushed
ECO MODE SW ECO mode switch OFF or ON OFF: Switch released -
ON: Switch pushed
Key Remind Sound*3 Cycle of the key reminder warning buzzer Normal, Slow or Fast Displays customize setting of Key Remind Sound -
Driver Side Seatbelt Warning Buzzer Setting of driver side seat belt warning buzzer OFF or ON OFF: Seat belt warning buzzer does not sound at vehicle speed of 20 km/h (12 mph) or more when driver seat belt unfastened Displays customize setting of Driver Side Seat Belt Warning Buzzer
ON: Seat belt warning buzzer sounds at vehicle speed of 20 km/h (12 mph) or more when driver seat belt unfastened
P-Seatbelt Warning Buzzer Setting of front passenger side seat belt warning buzzer OFF or ON OFF: Seat belt warning buzzer does not sound at vehicle speed of 20 km/h (12 mph) or more when front passenger seat belt unfastened Displays customize setting of Front Passenger Side Seat Belt Warning Buzzer
ON: Seat belt warning buzzer sounds at vehicle speed of 20 km/h (12 mph) or more when front passenger seat belt unfastened
ODO Display Time After IG OFF Setting Setting of ODO display time after the ignition switch is turned off 30s, 60s, 600s or OFF Displays customize setting of ODO Display Time After the Ignition Switch is Turned Off -
TPMS System Existence of tire pressure warning system With or Without With: w/ Tire Pressure Warning System -
Without: w/o Tire Pressure Warning System
LDA System Existence of lane departure alert system With or Without With: w/ Lane Departure Alert System -
Without: w/o Lane Departure Alert System
PCS System Existence of pre-collision system With or Without With: w/ Pre-collision System -
Without: w/o Pre-collision System
Number of Trouble Code The number of DTCs currently stored Min.: 0, Max.: 255 Number of stored DTCs displayed -

HINT:

*A: When a passenger is detected in the front passenger seat.

*B: The temperature displayed on the multi-information display is -40 to 50°C (-40 to 122°F).

*C: "Unset" is displayed when the vehicle is stopped and the ignition switch is ON (READY).


*1: w/ Light Control Rheostat

*2: w/ Occupant Classification System

*3: This item is displayed on the GTS, but does not apply to vehicles with a Smart Entry and Start System.


Chassis / ABS/VSC/TRC / Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note
Vehicle Speed Maximum wheel speed sensor Min.: 0 km/h (0 mph), Max.: 326 km/h (202 mph) Vehicle stopped: 0 km/h (0 mph) When driving at constant speed: No large fluctuations

Powertrain / Engine and ECT / Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note
Coolant Temp Coolant temperature Min.: -40°C (-40°F), Max.: 140°C (284°F) 75 to 100°C (167 to 212°F): After warming up
·

Stored as Freeze Frame Data

·

This is the engine coolant temperature.


HINT:
·

After warming up the engine, the engine coolant temperature is 75 to 100°C (167 to 212°F).

·

After a long soak, the engine coolant temperature, intake air temperature and ambient air temperature are approximately equal.

·

If the value is -40°C (-40°F), or higher than 135°C (275°F), the sensor circuit is open or shorted.

·

Check if the engine overheats when the value indicates higher than 135°C (275°F).






ACTIVE TEST


HINT:

Using the GTS to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.


a.

Connect the GTS to the DLC3.


b.

Turn the ignition switch to ON (IG).


c.

Turn the GTS on.


d.

Enter the following menus: Body Electrical / Combination Meter / Active Test.


e.

Perform the Active Test according the display on the GTS.

Body Electrical / Combination Meter / Active Test
Tester Display Test Part Control Range Diagnostic Note
Speed Meter Operation Speedometer OFF, 0, 40, 80, 120 or 160 There is a deviation in the values displayed on the speedometer (Control range → Speedometer display)
Reference mph:
·

40 → 42.0 to 44.0

·

80 → 83.0 to 87.0

·

120 → 125.0 to 129.0

·

160 → 166.0 to 171.0


Reference km/h (w/o Room Light)
·

40 → 42.0 to 46.0

·

80 → 84.0 to 88.0

·

120 → 125.0 to 130.0

·

160 → 167.0 to 173.0


Reference km/h (w/ Room Light)
·

40 → 40.1 to 42.1

·

80 → 80.2 to 82.2

·

120 → 120.2 to 122.2

·

160 → 160.3 to 162.3


Fuel Meter Operation Fuel receiver gauge OFF, Sender E, Empty, Warning, 1/4, 1/2, 3/4, Full or Sender F -
A/T Indicator Operation 1 Shift indicator OFF, D, N, R or P *A
A/T Indicator Operation 2 Shift indicator OFF or B -
Indicat. Lamp Airbag SRS warning light OFF or ON -
Driver Side Seat Belt Driver or front passenger seat belt warning light OFF or ON -
Indicat. Lamp ABS ABS warning light OFF or ON -
Indicat. Lamp Slip Slip indicator light OFF or ON -
Indicat. Lamp Tail Tail indicator light OFF or ON -
Indicat. Lamp Fuel Fuel level warning light OFF or ON -
Indicat. Tire Pressure Warning System*1 Tire pressure warning light OFF or ON -
Indicat. Lamp ECB Brake warning light / yellow (minor malfunction) OFF or ON -
Indicat. Lamp Cruise*2 Cruise control indicator light OFF or ON -
Indicat. Lamp Brake Brake warning light / red (malfunction) OFF or ON -
Indicat. EPS EPS warning light OFF or ON -
Master Warning Master warning light OFF or ON -
Indicat. Ready (HV) Ready indicator light OFF or ON -
Indicat. EV Mode EV mode indicator light OFF or ON -
Indicat. Park Parking brake indicator light OFF or ON -
Indicat. SET*2 Cruise SET indicator light OFF or ON -
Indicat. VSC OFF VSC OFF indicator light OFF or ON -
Indicat. ECO MODE ECO MODE indicator light OFF or ON -
Turn Signal (Left) Indicator LH turn indicator light OFF or ON -
Turn Signal (Right) Indicator RH turn indicator light OFF or ON -
HV System Indicator Hybrid system indicator OFF, MIN, -50, 0, 100, 200, 300, 400 or MAX -
Meter Display 1 Segment display
Multi-information display
OFF, 0, 1, 2, 3, 4, 5, 6 or ALL *B
Meter Display 2 Segment display OFF, 7, 8 or 9 -

HINT:

*A: A buzzer will sound when "R" is selected.

*B: The multi-information display and all segments of the segment display will illuminate when "ALL" is selected.


*1: w/ Tire Pressure Warning System

*2: w/ Cruise Control System