Home › Vehicle Exterior › MIRROR (EXT) › OUTER REAR VIEW MIRROR › from 2019.07
RM2170E _59 Vehicle Exterior _057047 MIRROR (EXT) _0278168 OUTER REAR VIEW MIRROR A

MIRROR (EXT)  OUTER REAR VIEW MIRROR  DISASSEMBLY  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH side and LH side.

·

The following procedure is for the LH side.



PROCEDURE

Hide 81740 1.REMOVE SIDE TURN SIGNAL LIGHT ASSEMBLY (for Bulb Type Turn Signal Light)

Hide 2.REMOVE OUTER MIRROR RETRACTOR (for Bulb Type Turn Signal Light)

w/ Power Retractable Mirror:

a.
B308824E01
2.513,1.785 2.726,1.935 0.213,0.149 10 *a

Cut the wire harness at the position shown in the illustration.

Text in Illustration
*a Cut the wire harness here


b.
B308825

Remove the vinyl tape from the gasket.


c.
B308826

Disengage the 2 claws and 7 guides to remove the gasket.


d.
B308827

Disengage the 4 claws and remove the stay cover.


e.
B308828

Remove the 3 screws and stay.


f.
B308829

Remove the 3 screws and disconnect the unit drive assembly.


g.
B411976

Disengage the clamp.


h.

Disconnect the connector and remove the unit drive assembly.


i.
B308831

Remove the 5 screws and reinforcement.


j.
B411114

Disconnect the connector.


k.

Disengage the 2 clamps.


l.
B411115

Remove the wire harness as shown in the illustration.

NOTICE:

Make sure to replace the wire harness with a new one.



m.
B411116

Remove the screw and retractor assembly.

NOTICE:

Make sure to replace the retractor assembly with a new one.



Hide 8794A 3.REMOVE NO. 2 OUTER MIRROR COVER (for LED Type Turn Signal Light)

a.
E421425

Remove the screw.


b.
E421426C02
0,0 0,0 false
V113146

Place Hand Here


Pull the No. 2 outer mirror cover as shown in the illustration to disengage the 3 claws and 2 guides and remove it.

NOTICE:

As the claws and guides may be damaged, make sure not to apply force in any direction other than shown in the illustration.


HINT:

If it is difficult to disengage the claws, disengage them using a screwdriver with its tip wrapped with protective tape.



Hide 81730 4.REMOVE SIDE TURN SIGNAL LIGHT ASSEMBLY (for LED Type Turn Signal Light)