Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
87961
1.REMOVE OUTER MIRROR
87945
2.REMOVE OUTER MIRROR COVER (for Bulb Type Turn Signal Light)
Push the outside part of the outer mirror assembly and tilt it as shown in the illustration.
Remove the screw.
Disengage the guide and remove the visor inner cover.
Disengage the claw at bottom of the outer rear view mirror assembly.
Disengage the 4 claws and remove the outer mirror cover.
If it is difficult to disengage the claws, disengage them using a screwdriver with its tip wrapped with protective tape.
Return the outer mirror assembly and tilt it to original position.
87945
3.REMOVE OUTER MIRROR COVER (for LED Type Turn Signal Light)
|
Move in this Direction |
Push the outside part of the outer mirror assembly and tilt it as shown in the illustration.
| *a | Protective Tape |
Using a screwdriver, disengage the claw as shown in the illustration.
Tape the screwdriver tip before use.
Disengage the 7 claws to remove the outer mirror cover.
If it is difficult to disengage the claws, disengage them using a screwdriver with its tip wrapped with protective tape.
Return the outer mirror assembly and tilt it to original position.