Home › Engine / Hybrid System › 2ZR-FXE (ENGINE CONTROL) › MASS AIR FLOW METER
RM2070E _51 Engine / Hybrid System _061905 2ZR-FXE ENGINE CONTROL _0301564 MASS AIR FLOW METER G

2ZR-FXE ENGINE CONTROL  MASS AIR FLOW METER  ON-VEHICLE INSPECTION  


CAUTION / NOTICE / HINT

NOTICE:
·

Perform the mass air flow meter inspection in accordance with the following procedure.

·

Replace the mass air flow meter only when foreign matter adheres to the sensor and the MAF value in the Data List (with the engine stopped) is not within the normal operating range.



PROCEDURE

Hide 22204 1.INSPECT MASS AIR FLOW METER

a.

Read the values using the GTS (MAF).

NOTICE:
·

Perform the inspection with the vehicle indoors and on a level surface.

·

Perform the inspection of the mass air flow meter while it is installed into the air cleaner case (installed on the vehicle).

·

During the test, do not use an exhaust air duct on the exhaust pipe.



i.

Connect the GTS to the DLC3.


ii.

Turn the power switch on (IG) (do not run the engine).


iii.

Turn the GTS on.


iv.

Enter the following menus: Powertrain / Engine and ECT / Data List / Primary / MAF.


v.

Wait 30 seconds, and read the values on the GTS.

Standard Condition:
Tester Display Condition Standard Condition
MAF
·

Engine not running


·

30 seconds after power switch is turned on (IG)


0.26 g/sec or less


·

If the result is not as specified, replace the mass air flow meter.

·

If the result is within the specified range, remove and inspect the mass air flow meter (See page Engine / Hybrid System>2ZR-FXE (ENGINE CONTROL)>MASS AIR FLOW METER>INSPECTION).