The hybrid vehicle control ECU transmits and receives signals via CAN communication to and from the ECM, skid control ECU assembly, power steering ECU assembly, main body ECU, airbag ECU assembly, and air conditioning amplifier assembly.
| DTC No. | INF Code | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| U0100 | 211 | Problem with CAN communication between the ECM and hybrid vehicle control ECU (communication error between ECUs) | CAN communication system |
| 212 | Problem with CAN communication between the ECM and hybrid vehicle control ECU (signal transmission error) | ||
| 530 | Problem with CAN communication between the ECM and hybrid vehicle control ECU (CAN communication system malfunction) | ||
| U0129 | 220 | Problem with CAN communication between the skid control ECU assembly and hybrid vehicle control ECU (no signal reception) | |
| 222 | Problem with CAN communication between the skid control ECU assembly and hybrid vehicle control ECU (signal transmission error) | ||
| 527 | Problem with CAN communication (V BUS) between the skid control ECU assembly and hybrid vehicle control ECU (CAN communication system malfunction) | ||
| 528 | Problem with CAN communication between the skid control ECU assembly and hybrid vehicle control ECU (CAN communication system malfunction) | ||
| U0140 | 146 | Problem with CAN communication between the main body ECU and hybrid vehicle control ECU (CAN communication system malfunction) | |
| U0151 | 763 | Problem with CAN communication between airbag ECU assembly and hybrid vehicle control ECU (CAN communication system malfunction) | |
| U0164 | 594 | Problem with CAN communication between the air conditioning amplifier assembly and hybrid vehicle control ECU (communication error between ECUs) | |
| 827 | Problem with CAN communication between air conditioning amplifier assembly and hybrid vehicle control ECU (CAN communication system malfunction) | ||
| U1107 | 436 | Problem with CAN communication between the power source ECU and hybrid vehicle control ECU (CAN communication system malfunction) |
After the repair, clear the DTCs and perform the following procedure to check that DTCs are not output.
Turn the power switch on (IG) and wait for 2 minutes or more.
Connect the GTS to the DLC3.
Turn the power switch on (IG).
Check for DTCs of all systems by following the prompts on the GTS screen.
Check if DTCs are output.
| Result | Proceed to |
|---|---|
| Hybrid vehicle control ECU outputs P2532-772 | A |
| Hybrid vehicle control ECU does not output P2532-772
(w/ Central Gateway ECU) |
B |
| Hybrid vehicle control ECU does not output P2532-772
(w/o Central Gateway ECU) |
C |
Turn the power switch off.
A
B
C