Home › Engine / Hybrid System › HYBRID / BATTERY CONTROL › HV RELAY ASSEMBLY › from 2016.05
RM2070E _51 Engine / Hybrid System _061906 HYBRID / BATTERY CONTROL _0301584 HV RELAY ASSEMBLY A

HYBRID / BATTERY CONTROL  HV RELAY ASSEMBLY  INSTALLATION  


PROCEDURE

Hide G92Z0 1.INSTALL HYBRID BATTERY JUNCTION BLOCK ASSEMBLY

CAUTION:

Wear insulated gloves.


a.

Install the hybrid battery junction block assembly with the 3 nuts.

Torque:
7.5 N*m (76 kgf*cm, 66 in.*lbf)


b.

Connect the 4 hybrid battery junction block assembly connectors.

NOTICE:

Make sure that the connector is connected securely.



c.

Engage the clamp.


Hide G920R 2.INSTALL NO. 2 HYBRID BATTERY SHIELD SUB-ASSEMBLY

CAUTION:

Wear insulated gloves.


a.
A251487E02
2.823,1.563 2.969,1.74 0.146,0.177 10 false A 2.125,1.958 2.271,2.135 0.146,0.177 10 false A 1.188,1.771 1.333,1.948 0.146,0.177 10 false A 1.01,0.156 1.156,0.333 0.146,0.177 10 false A 2.531,1.854 2.698,2.073 0.167,0.219 10 true B

Install the No. 2 hybrid battery shield sub-assembly with the 5 bolts.

Torque:
Bolt A : 7.5 N*m (76 kgf*cm, 66 in.*lbf)
Bolt B : 19 N*m (194 kgf*cm, 14 ft.*lbf)


Hide 5. CURRENT SENSOR OFFSET LEARNING

HINT:

Perform this procedure when the hybrid battery junction block assembly or hybrid vehicle control ECU has been replaced.


a.

Connect the GTS to the DLC3.


b.

Turn the power switch on (READY).


c.

Perform a road test.

NOTICE:

Accelerate/decelerate gently. Avoid rapid acceleration/deceleration.


i.

Enter the following menus: Powertrain / Hybrid Control / Data List / Power Resource IB.


ii.

Drive the vehicle with the value of Data List item "Power Resource IB" between -50 A and 50 A.


iii.

Distance and driving time are not specified.


iv.

Turn the power switch off and leave the vehicle for 30 seconds or more.


v.

Turn the power switch on (IG).


vi.

Enter the following menus: Powertrain / Hybrid Control / Data List / Power Resource IB.


vii.

Check that the value of "Power Resource IB" is between - 0.5 A and 0.5 A with the power switch on (IG).

NOTICE:

If the value is outside the specified range, perform the road test again.


HINT:
·

If the power switch is on (IG) and value of "Power Resource IB" is between - 0.5 A and 0.5 A, current sensor offset learning has been completed.

·

Even if the current sensor offset learning is not complete, the current sensor value will be corrected by repeating the road test a maximum of 7 times.