Home › Engine / Hybrid System › HYBRID / BATTERY CONTROL › HV BATTERY › from 2016.05
RM2070E _51 Engine / Hybrid System _061906 HYBRID / BATTERY CONTROL _0301578 HV BATTERY A

HYBRID / BATTERY CONTROL  HV BATTERY  INSTALLATION  


PROCEDURE

Hide G92X2 1.INSTALL NO. 2 HYBRID BATTERY PACK WIRE

a.

Install the No. 2 hybrid battery pack wire with the 2 clamps.


Hide G92Z0 2.INSTALL HYBRID BATTERY JUNCTION BLOCK ASSEMBLY

Hide G920R 3.INSTALL NO. 2 HYBRID BATTERY SHIELD SUB-ASSEMBLY

CAUTION:

Wear insulated gloves.


a.

Install the No. 2 hybrid battery shield sub-assembly with the 4 bolts.

Torque:
7.5 N*m (76 kgf*cm, 66 in.*lbf)


b.
A249908

Install the electric vehicle battery plug assembly with the bolt as shown in the illustration.

Torque:
7.5 N*m (76 kgf*cm, 66 in.*lbf)


c.

Connect the connector.

NOTICE:

Make sure that the connector is connected securely.



d.

Connect the clamp.


e.

Connect the connector and clamp.

NOTICE:

Make sure that the connector is connected securely.



Hide G92N2 5.INSTALL NO. 2 HYBRID VEHICLE BATTERY COVER PANEL LH

CAUTION:

Wear insulated gloves.


a.

Install the No. 2 hybrid vehicle battery cover panel LH with the 4 bolts.

Torque:
7.5 N*m (76 kgf*cm, 66 in.*lbf)


b.

Connect the connector.


Hide G9510 6.INSTALL HV BATTERY

CAUTION:

Wear insulated gloves.


NOTICE:
·

Insulate the removed connectors and terminals with insulating tape.

·

Since the HV battery is very heavy, 2 people are needed to remove the HV battery.

·

Use cardboard or other similar material to protect the HV battery and vehicle body from damage.

·

When moving the hybrid battery, make sure to use an engine lifter.



a.
A251498E02
2.74,1.219 3.01,1.219 true 2.823,1.583 2.99,1.583 true 1.26,2.771 1.427,2.771 false 1.177,2.385 1.344,2.385 false 3.031,1.146 3.26,1.354 0.229,0.208 10 true *1 3.031,1.521 3.26,1.729 0.229,0.208 10 false *2 1.458,2.708 1.688,2.917 0.229,0.208 10 true *3 1.365,2.313 1.594,2.521 0.229,0.208 10 true *1

Insert the guide pins into the front hybrid battery guide and rear hybrid battery guide to temporarily install the HV battery in the vehicle.

Text in Illustration
*1 Guide Pin
*2 Front Hybrid Battery Guide
*3 Rear Hybrid Battery Guide

NOTICE:

Take care not to deform the guide pins.



b.

Install the HV battery to the vehicle with the 6 bolts.

Torque:
19 N*m (194 kgf*cm, 14 ft.*lbf)


c.

Install the floor carpet to the HV battery.


d.

Connect the 2 connectors to the battery smart unit.


Hide G92D4 7.INSTALL NO. 4 HYBRID BATTERY INTAKE DUCT

a.

Install the No. 4 hybrid battery intake duct with the 2 clips.


Hide G92F1 8.INSTALL NO. 1 HYBRID BATTERY EXHAUST DUCT

a.

Install the No. 1 hybrid battery exhaust duct with the 2 clips.


Hide 82164 9.CONNECT FRAME WIRE

CAUTION:

Wear insulated gloves.


a.

Using an insulated tool, connect the frame wire with the 3 nuts.

Torque:
9.0 N*m (92 kgf*cm, 80 in.*lbf)

NOTICE:

Be sure to connect the frame wires to the correct terminals.



Hide G920Q 10.INSTALL NO. 1 HYBRID BATTERY SHIELD SUB-ASSEMBLY

CAUTION:

Wear insulated gloves.


a.

Connect the 4 connectors to the battery smart unit.


b.

Check high voltage cable connection condition.

i.

Check that each wire harness is being installed securely.

A400623E01
6.125,2.344 6.5,1.094 6.5,1.094 6.667,1.094 false 6.479,3.552 6.792,3.75 0.313,0.198 10 false *a 6.729,1.01 7.042,1.208 0.313,0.198 10 false *1

Text in Illustration
*1 Frame Wire *a Front of Vehicle

NOTICE:
·

Be sure to connect the frame wire to the correct terminals as shown in the illustration.

·

The connectors should be connected securely.

·

The nuts should be fastened securely.





c.

Install the No. 1 hybrid battery shield sub-assembly with the 4 bolts.

Torque:
7.5 N*m (76 kgf*cm, 66 in.*lbf)


d.

Connect the 2 clamps and electrical key oscillator clamp.


Hide 58817A 12.INSTALL FRONT NO. 2 CONSOLE BOX INSERT

Hide 58804A 13.INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY

Hide 18.PERFORM UTILITY

NOTICE:

Perform "Battery Status Info Update" after replacing the malfunctioning HV battery (See page Engine / Hybrid System>HYBRID / BATTERY CONTROL>HYBRID BATTERY SYSTEM>UTILITY).