89892A
1.REMOVE BATTERY SMART UNIT
82164
2.DISCONNECT FRAME WIRE
G920R
3.REMOVE NO. 2 HYBRID BATTERY SHIELD SUB-ASSEMBLY
Wear insulated gloves.
Insulate the disconnected connectors with insulating tape.
Disconnect the connector and clamp.
Disconnect the clamp.
Disconnect the connector.
Remove the bolt and electric vehicle battery plug assembly as shown in the illustration.
Remove the 5 bolts and No. 2 hybrid battery shield sub-assembly.
G92Z0
4.REMOVE HYBRID BATTERY JUNCTION BLOCK ASSEMBLY
Wear insulated gloves.
Insulate the disconnected connectors with insulating tape.
Disconnect the clamp.
Disconnect the 4 connectors from the hybrid battery junction block assembly.
Remove the 3 nuts and hybrid battery junction block assembly.