Home › Engine / Hybrid System › HYBRID / BATTERY CONTROL › SERVICE PLUG GRIP › 2014.11–2016.05
RM2070E _51 Engine / Hybrid System _061906 HYBRID / BATTERY CONTROL _0301586 SERVICE PLUG GRIP A

HYBRID / BATTERY CONTROL  SERVICE PLUG GRIP  INSTALLATION  


PROCEDURE

Hide G3834 1.INSTALL SERVICE PLUG GRIP

CAUTION:

Wear insulated gloves.


NOTICE:
·

Before connecting the service plug, check that no parts and tools remain and that the high voltage terminals and connectors are connected securely.

·

Connect the auxiliary battery on the same day of installing the service plug grip to allow the battery cell voltage equalization function of the battery smart unit to operate.



a.

Wear insulated gloves and install the service plug grip in the order shown in the illustration.

A251474


b.

Rotate the handle of the service plug grip 90° toward the battery and slide it in the direction shown by the arrow until a click sound is heard.


Hide G92Q7 2.INSTALL NO. 5 HYBRID BATTERY SHIELD PANEL

a.
A251471

Install the No. 5 hybrid battery shield panel with the 3 claws in the order shown in the illustration.


Hide 3.CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).