1.REMOVE FRONT SEAT ASSEMBLY RH
67913
2.REMOVE FRONT DOOR SCUFF PLATE RH
Use the same procedure as for the LH side (See page Vehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING>REMOVAL).
62111C
3.REMOVE COWL SIDE TRIM SUB-ASSEMBLY RH
Use the same procedure as for the LH side (See page Vehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING>REMOVAL).
67917A
4.REMOVE REAR DOOR SCUFF PLATE RH
Use the same procedure as for the LH side (See page Vehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING>REMOVAL).
73233
5.REMOVE LAP BELT OUTER ANCHOR COVER (for RH Side)
73210
6.DISCONNECT FRONT SEAT OUTER BELT ASSEMBLY
62311B
7.DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP RH
Use the same procedure as for the LH side (See page Vehicle Interior>SEAT BELT>FRONT SEAT OUTER BELT ASSEMBLY>REMOVAL).
62331A
8.DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP RH
Use the same procedure as for the LH side (See page Vehicle Interior>SEAT BELT>FRONT SEAT OUTER BELT ASSEMBLY>REMOVAL).
62413A
9.REMOVE CENTER PILLAR LOWER GARNISH RH
Use the same procedure as for the LH side (See page Vehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING>REMOVAL).
77306
10.REMOVE FUEL LID LOCK OPEN LEVER SUB-ASSEMBLY (for RHD)
G9230
11.REMOVE BATTERY COOLING BLOWER ASSEMBLY
Be sure not to touch the fan part of the battery cooling blower assembly.
Do not lift the battery cooling blower assembly using the wire harness.
Disconnect the 2 clips and remove the No.1 rear heater register bezel.
Turn over the front floor carpet.
Remove the 3 clips and No. 1 hybrid battery intake duct.
Disconnect the connector.
Remove the 2 bolts.
Remove the 3 nuts and battery cooling blower assembly from the battery cooling blower bracket.
G92D2
12.REMOVE NO. 2 HYBRID BATTERY INTAKE DUCT
Perform this procedure only when replacement of the No. 2 hybrid battery intake duct is necessary.
Remove the HV battery (See page Engine / Hybrid System>HYBRID / BATTERY CONTROL>HV BATTERY>REMOVAL).
Remove the 2 clips and No. 2 hybrid battery intake duct.