11302A
1.INSTALL TIMING CHAIN COVER OIL SEAL
Apply MP grease to the lip of a new oil seal.
Keep the lip free from foreign matter.
Using SST and a hammer, tap in the oil seal until its surface is flush with the front oil seal retainer edge.
Wipe off extra grease from the crankshaft.
Do not tap the oil seal at an angle.
13471
2.INSTALL CRANKSHAFT PULLEY
Align the pulley set key with the key groove of the pulley.
Using SST, hold the pulley in place and tighten the bolt.
| *a | Hold |
| *b | Turn |
51107A
3.INSTALL REAR SIDE RAIL REINFORCEMENT SUB-ASSEMBLY RH
4.INSPECT FOR OIL LEAK
51443C
5.INSTALL REAR ENGINE UNDER COVER RH
6.INSTALL FRONT WHEEL RH