Home › Engine / Hybrid System › 2ZR-FXE (ENGINE MECHANICAL) › FRONT CRANKSHAFT OIL SEAL › 2012.03–2014.11
RM2070E _51 Engine / Hybrid System _061907 2ZR-FXE ENGINE MECHANICAL _0301596 FRONT CRANKSHAFT OIL SEAL A

2ZR-FXE ENGINE MECHANICAL  FRONT CRANKSHAFT OIL SEAL  REMOVAL  


PROCEDURE

Hide 1.REMOVE FRONT WHEEL RH

Hide 51443C 2.REMOVE REAR ENGINE UNDER COVER RH

Hide 51107A 3.REMOVE REAR SIDE RAIL REINFORCEMENT SUB-ASSEMBLY RH

Hide 13471 4.REMOVE CRANKSHAFT PULLEY

a.
A213052E02
2.791,0.482 3.113,0.630 0.323,0.149 10 SST 1.754,1.954 2.757,0.573 2.757,0.573 1.456,1.659 false 0.124,1.99 0.282,2.139 0.158,0.149 10 *a 1.529,3.141 1.697,3.293 0.168,0.152 10 *b 0.299,2.072 0.758,2.072 false

Using SST, hold the pulley in place and loosen the pulley bolt.

Text in Illustration
*a Hold
*b Turn

SST
09213-58014  (91551-80840)
09330-00021  


b.
A213053E02
0.346,2.484 0.655,2.640 0.309,0.156 10 SST 0.707,2.573 0.841,2.573 0.841,2.573 0.991,2.334 false 0.235,2.12 0.397,2.286 0.162,0.166 10 *a 0.424,2.223 0.527,2.223 0.527,2.223 0.666,2.084 false 0.922,3.127 1.088,3.275 0.166,0.148 10 *b

Using SST, remove the crankshaft pulley and pulley bolt.

Text in Illustration
*a Hold
*b Turn

SST
09950-50013  (09951-05010, 09952-05010, 09953-05020, 09954-05021)

HINT:

If necessary, remove the pulley and pulley bolt using SST.



Hide 11302A 5.REMOVE TIMING CHAIN COVER OIL SEAL

a.

Using a knife, cut off the lip of the oil seal.


b.
A112529E11
2.115,2.281 2.229,2.656 2.229,2.656 3.021,2.313 false 2.156,2.677 2.323,2.844 0.167,0.167 10 false *a

Using a screwdriver with its tip wrapped with tape, pry out the oil seal.

Text in Illustration
*a Cut Position

NOTICE:

After removing, check the crankshaft for damage. If damaged, smooth the surface with 400-grit sandpaper.