Home › Engine / Hybrid System › 2ZR-FXE (ENGINE MECHANICAL) › FRONT CRANKSHAFT OIL SEAL › from 2014.11
RM2070E _51 Engine / Hybrid System _061907 2ZR-FXE ENGINE MECHANICAL _0301596 FRONT CRANKSHAFT OIL SEAL A

2ZR-FXE ENGINE MECHANICAL  FRONT CRANKSHAFT OIL SEAL  REMOVAL  


PROCEDURE

Hide 1.REMOVE FRONT WHEEL RH

Hide 51443C 2.REMOVE REAR ENGINE UNDER COVER RH

Hide 51107A 3.REMOVE REAR SIDE RAIL REINFORCEMENT SUB-ASSEMBLY RH

Hide 13471 4.REMOVE CRANKSHAFT PULLEY

a.
A335150E04
1.396,1.75 2.688,0.75 2.688,0.75 1.688,2.052 false 0.427,2.229 0.688,2.229 false 0.25,2.135 0.563,2.292 0.313,0.156 10 false *a 2.75,0.625 3.208,0.823 0.458,0.198 10 false SST 1.531,3.24 1.844,3.396 0.313,0.156 10 false *b

Using SST, hold the pulley in place and loosen the pulley bolt.

Text in Illustration
*a Hold
*b Turn

SST
09213-58014  (91551-80840)
09330-00021  


b.
A335151E04
0.646,2.635 0.823,2.635 0.823,2.635 0.979,2.396 false 0.469,2.365 0.625,2.365 0.625,2.365 0.75,2.229 false 0.26,2.271 0.573,2.427 0.313,0.156 10 false *a 0.323,2.552 0.781,2.75 0.458,0.198 10 false SST 0.854,3.177 1.167,3.333 0.313,0.156 10 false *b

Using SST, remove the crankshaft pulley and pulley bolt.

Text in Illustration
*a Hold
*b Turn

SST
09950-50013  (09951-05010, 09952-05010, 09953-05020, 09954-05021)

HINT:

If necessary, remove the pulley and pulley bolt using SST.



Hide 11302A 5.REMOVE TIMING CHAIN COVER OIL SEAL

a.

Using a knife, cut off the lip of the oil seal.


b.
A112529E11
2.115,2.281 2.229,2.656 2.229,2.656 3.021,2.313 false 2.156,2.677 2.323,2.844 0.167,0.167 10 false *a

Using a screwdriver with its tip wrapped with tape, pry out the oil seal.

Text in Illustration
*a Cut Position

NOTICE:

After removing, check the crankshaft for damage. If damaged, smooth the surface with 400-grit sandpaper.