1. PRECAUTION
After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
2. DISCHARGE FUEL SYSTEM PRESSURE
58410B
3.REMOVE DECK BOARD ASSEMBLY
58411A
4.REMOVE NO. 1 DECK BOARD
58412A
5.REMOVE NO. 2 DECK BOARD
64993
6.REMOVE REAR DECK FLOOR BOX
64995
7.REMOVE DECK FLOOR BOX RH
8.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
25601L
9.REMOVE EGR WITH COOLER PIPE SUB-ASSEMBLY
82121
10.DISCONNECT ENGINE WIRE
Disconnect the 4 fuel injector connectors.
Disconnect the 4 connectors.
Remove the bolt.
Disconnect the 2 clamps to disconnect the engine wire.
23901
11.DISCONNECT FUEL TUBE SUB-ASSEMBLY
Release the claw and remove the No. 1 fuel pipe clamp.
Pinch the fuel tube connector, and then pull the fuel tube connector off of the fuel pipe.
Check for foreign matter in the fuel tube around the fuel tube connector. Clean it if necessary. Foreign matter can affect the ability of the O-ring to seal the fuel tube connector and fuel pipe.
Do not use any tools to separate the fuel tube connector and fuel pipe.
Do not forcefully bend, kink or twist the hose.
Keep the fuel tube connector and fuel pipe free from foreign matter.
If the fuel tube connector and fuel pipe are stuck together, pinch the fuel tube connector and turn it carefully to disconnect it.
Put the fuel tube connector in a plastic bag to prevent damage and contamination.
23807
12.REMOVE FUEL DELIVERY PIPE SUB-ASSEMBLY
Remove the bolt.
Remove the 2 bolts and fuel delivery pipe sub-assembly.
Be careful not to drop the fuel injectors when removing the fuel delivery pipe.
23807V
13.REMOVE NO. 1 DELIVERY PIPE SPACER
Remove the 2 delivery pipe spacers from the cylinder head.
23250
14.REMOVE FUEL INJECTOR ASSEMBLY
Pull the 4 fuel injector assemblies out of the fuel delivery pipe sub-assembly.
Remove the O-ring from each fuel injector assembly.
For reinstallation, attach a tag or label to each injector shaft.
Prevent entry of foreign matter by covering the fuel injectors with plastic bags.
Remove the 4 injector vibration insulators.