12204
1.INSTALL VENTILATION VALVE SUB-ASSEMBLY
Apply adhesive to 2 or 3 threads of the ventilation valve sub-assembly.
Toyota genuine adhesive 1324, three bond 1324 or equivalent
Using a ball joint lock nut wrench (22 mm), install the ventilation valve sub-assembly.
Use the torque value compensation formula to calculate the torque value for use when a torque wrench is combined with a tool such as a ball joint lock nut wrench (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
Install the ventilation hose to the valve and intake manifold.
51441
2.INSTALL NO. 1 ENGINE UNDER COVER
3.INSTALL AIR CLEANER CASE
17750A
4.INSTALL INLET AIR CLEANER ASSEMBLY
17705
5.INSTALL AIR CLEANER CAP SUB-ASSEMBLY
11212
6.INSTALL NO. 2 CYLINDER HEAD COVER