Home › Engine / Hybrid System › 2ZR-FXE (INTAKE / EXHAUST) › INTAKE MANIFOLD › 2012.03–2012.10
RM2070E _51 Engine / Hybrid System _061910 2ZR-FXE INTAKE / EXHAUST _0301617 INTAKE MANIFOLD A

2ZR-FXE INTAKE / EXHAUST  INTAKE MANIFOLD  REMOVAL  


PROCEDURE

Hide 22210 1.REMOVE THROTTLE BODY ASSEMBLY

Hide 89421 3.REMOVE MANIFOLD ABSOLUTE PRESSURE SENSOR

Hide 17111 5.REMOVE INTAKE MANIFOLD

a.
A212682

Disconnect the 3 connectors and 2 wire harness clamps.


b.

Remove the engine oil level dipstick.


c.
A212681

Disconnect the wire harness clamp, and then remove the 2 bolts and engine oil level dipstick guide sub-assembly.


d.

Remove the O-ring from the engine oil level dipstick guide sub-assembly.


e.
A212683

Disconnect the fuel vapor feed hose and ventilation hose.


f.
A212684

Remove the 2 bolts, 2 nuts and intake manifold.


g.

Remove the No. 1 intake manifold to head gasket.


Hide 6.REPLACE STUD BOLT

HINT:

If a stud bolt is deformed or the threads are damaged, replace it.


a.
A212685

Using an E6 "TORX" socket wrench, replace the 2 stud bolts.

Torque:
5.0 N*m (51 kgf*cm, 44 in.*lbf)