Home › Engine / Hybrid System › 2ZR-FXE (COOLING) › TEMPERATURE SWITCH › 2012.03–2020.08
RM2070E _51 Engine / Hybrid System _061911 2ZR-FXE COOLING _0301625 TEMPERATURE SWITCH A

2ZR-FXE COOLING  TEMPERATURE SWITCH  INSTALLATION  


PROCEDURE

Hide 89429E 1.INSTALL ENGINE COOLANT TEMPERATURE SENSOR

a.

Using a union nut wrench (19 mm), install the engine coolant temperature sensor.

Torque:
8.0 N*m (82 kgf*cm, 71 in.*lbf)

NOTICE:

Do not apply any excessive force to the heater pipe when installing the engine coolant temperature sensor.



b.

Connect the connector.