Home › Engine / Hybrid System › 2ZR-FXE (LUBRICATION) › LUBRICATION SYSTEM › from 2014.11
RM2070E _51 Engine / Hybrid System _061912 2ZR-FXE LUBRICATION _0301632 LUBRICATION SYSTEM G

2ZR-FXE LUBRICATION  LUBRICATION SYSTEM  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 1.CHECK ENGINE OIL LEVEL

a.

Put the engine in inspection mode (See page General>INTRODUCTION>REPAIR INSTRUCTION>INSPECTION MODE PROCEDURE).


b.

Warm up and stop the engine, then wait for 5 minutes. The oil level should be between the low and full level marks on the engine oil level dipstick. If the engine oil level is low, check for leaks and add oil up to the full level mark.

NOTICE:

Do not fill with engine oil to above the full level mark.



Hide 2.CHECK ENGINE OIL

a.

Check the engine oil for deterioration, water contamination, discoloring or thinning. If the condition is visibly poor, replace the engine oil and oil filter element.


Hide 83530 3.INSPECT ENGINE OIL PRESSURE SWITCH ASSEMBLY

a.

b.
A154775

Install an oil pressure gauge with the adapter.


c.

Put the engine in inspection mode (See page General>INTRODUCTION>REPAIR INSTRUCTION>INSPECTION MODE PROCEDURE).


d.

Warm up the engine.


e.

Check the oil pressure.

Standard Oil Pressure:
Engine Condition Oil Pressure
Idle 60 kPa (0.6 kgf/cm2, 8.7 psi) or more
2500 rpm 142 kPa (1.4 kgf/cm2, 21 psi) or more



f.

If the oil pressure is not as specified, check the oil pump (See page Engine / Hybrid System>2ZR-FXE (LUBRICATION)>OIL PUMP>INSPECTION).