Home › Engine / Hybrid System › CRUISE CONTROL › CRUISE CONTROL SYSTEM › from 2016.05
RM2070E _51 Engine / Hybrid System _061914 CRUISE CONTROL _0301639 CRUISE CONTROL SYSTEM C

CRUISE CONTROL  CRUISE CONTROL SYSTEM  P1578  Brake System Malfunction  


DESCRIPTION

This DTC is output when the electronically controlled brake system has a problem. Check the electronically controlled brake system when this DTC is output.

DTC No. DTC Detection Condition Trouble Area
P1578 The hybrid vehicle control ECU receives a brake system error signal for 0.2 sec. or more while the cruise control is in operation
·

Electronically controlled brake system


·

Hybrid vehicle control ECU



WIRING DIAGRAM

E306619E04
2.135,0.594 2.75,0.792 0.615,0.198 10 false CA1H 2.135,1.094 2.75,1.292 0.615,0.198 10 false CA1L 4.948,0.573 5.563,0.771 0.615,0.198 10 false CA1H 4.948,1.073 5.563,1.271 0.615,0.198 10 false CA1L 2.615,0.417 3.229,0.615 0.615,0.198 10 false 37 2.625,0.917 3.24,1.115 0.615,0.198 10 false 38 4.656,0.396 5.271,0.594 0.615,0.198 10 false 25 4.667,0.906 5.281,1.104 0.615,0.198 10 false 24 0.969,1.583 1.583,1.781 0.615,0.198 10 false A58 0.958,1.74 3.99,2.063 3.031,0.323 10 false Brake Booster with Master Cylinder 0.833,2.458 3.865,2.781 3.031,0.323 10 false : CAN Bus Line 4.792,1.625 5.406,1.823 0.615,0.198 10 false L6 4.781,1.792 6.552,2.156 1.771,0.365 10 false Hybrid Vehicle Control ECU 0.948,2.031 3.979,2.354 3.031,0.323 10 false (Skid Control ECU)

CAUTION / NOTICE / HINT

HINT:

This circuit uses CAN communication. Therefore, if there are any malfunctions in the communication circuit, one or more DTCs in the CAN communication system are output.


PROCEDURE

1.CHECK DTC (ELECTRONICALLY CONTROLLED BRAKE SYSTEM)
a.

Connect the GTS to the DLC3.


b.

Turn the power switch on (IG).


c.

Turn the GTS on.


d.

Enter the following menus: Chassis / ABS/VSC/TRAC / Trouble Codes.


e.

Check for the DTC.

Result:
Result Proceed to
DTC is not output A
DTC is output B




A

2.CHECK FOR DTCs (DTC P1578)

B

2.CHECK FOR DTCs (DTC P1578)
a.

Connect the GTS to the DLC3.


b.

Turn the power switch on (IG).


c.

Turn the GTS on.


d.

Perform the following to make sure that the DTC detection conditions are met.

HINT:

If the detection conditions are not met, the malfunction cannot be detected.


i.

Drive at a speed of between approximately 40 km/h (25 mph) and 200 km/h (125 mph).


ii.

Turn the cruise control system on using the ON-OFF switch.


iii.

Push the -/SET switch to activate the cruise control.



e.

Enter the following menus: Powertrain / Cruise Control / Trouble Codes.


f.

Check for DTCs.

Result:
Result Proceed to
DTC is not output A
DTC P1578 is output B




A

B

3.REPLACE BRAKE BOOSTER WITH MASTER CYLINDER
3.REPLACE BRAKE BOOSTER WITH MASTER CYLINDER

Replace the brake booster with master cylinder (skid control ECU) (for LHD) (See page Brake>BRAKE SYSTEM (OTHER)>BRAKE BOOSTER (for LHD)>REMOVAL).

Replace the brake booster with master cylinder (skid control ECU) (for RHD) (See page Brake>BRAKE SYSTEM (OTHER)>BRAKE BOOSTER (for RHD)>REMOVAL).


NEXT

4.CHECK FOR DTCs (DTC P1578)
4.CHECK FOR DTCs (DTC P1578)
a.

Connect the GTS to the DLC3.


b.

Turn the power switch on (IG).


c.

Turn the GTS on.



e.

Perform the following to make sure that the DTC detection conditions are met.

HINT:

If the detection conditions are not met, the malfunction cannot be detected.


i.

Drive at a speed of between approximately 40 km/h (25 mph) and 200 km/h (125 mph).


ii.

Turn the cruise control system on using the ON-OFF switch.


iii.

Push the -/SET switch to activate the cruise control.



f.

Enter the following menus: Powertrain / Cruise Control / Trouble Codes.


g.

Check for DTCs.

Result:
Result Proceed to
DTC is not output A
DTC P1578 is output B




A

END

B