The driving support ECU assembly uses the millimeter wave radar sensor to detect obstacles in front of the vehicle.
When the millimeter wave radar sensor assembly is replaced with a new one, it acquires the country specification information from the driving support ECU assembly. Also, when the driving support ECU assembly is replaced with a new one, it receives the country specification information from the main body ECU. When the country specification information in the sensor and ECU do not match, DTC C1A0A is stored.
| DTC No. | DTC Detection Condition | Trouble Area |
|---|---|---|
| C1A0A | While power switch is on (IG), country specification information in driving support ECU assembly and front millimeter wave radar sensor do not match for 1 second or more while the dynamic radar cruise control is operating | ·
Millimeter wave radar sensor assembly ·
Driving support ECU assembly |
When the millimeter wave radar sensor is replaced with a new one, adjustment of the radar sensor beam axis must be performed (See page Engine / Hybrid System>CRUISE CONTROL>MILLIMETER WAVE RADAR SENSOR>ADJUSTMENT).
Connect the GTS to the DLC3.
Turn the power switch on (IG).
Clear the DTCs.
Enter the following menus: Powertrain / Radar Cruise / Data List.
Read the Data List and check the country specification information of the front millimeter wave radar sensor and vehicle.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
|---|---|---|---|
| Country# (F Radar Sens) | Millimeter wave radar sensor country signal / JPN, NA, EURO, AUS, OTHER | Actual country code | - |
| Result | Proceed to |
|---|---|
| Country specification information for vehicle and millimeter wave radar sensor match | A |
| Country specification information for vehicle and millimeter wave radar sensor do not match | B |
A
B
Connect the GTS to the DLC3.
Turn the power switch on (IG).
Clear the DTCs (See page Engine / Hybrid System>CRUISE CONTROL>DYNAMIC RADAR CRUISE CONTROL SYSTEM>DTC CHECK / CLEAR).
Perform the following to make sure that the DTC detection conditions are met.
If the detection conditions are not met, the malfunction cannot be detected.
Drive the vehicle at a speed of between 50 km/h (30 mph) and 170 km/h (105 mph).
Turn the cruise control system on using the cruise control switch (ON-OFF button).
Push the cruise control switch to -/SET to begin control of vehicle speed using the cruise control system.
Enter the following menus: Powertrain / Radar Cruise / Trouble Codes.
Check for DTCs.
| Result | Proceed to |
|---|---|
| DTC is not output | A |
| DTC C1A0A is output | B |
A
(See pageGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING)
B