Home › Engine / Hybrid System › CRUISE CONTROL › DYNAMIC RADAR CRUISE CONTROL SYSTEM › 2016.05–2017.12
RM2070E _51 Engine / Hybrid System _061914 CRUISE CONTROL _0301640 DYNAMIC RADAR CRUISE CONTROL SYSTEM C

CRUISE CONTROL  DYNAMIC RADAR CRUISE CONTROL SYSTEM  C1A11  Front Radar Sensor Incorrect Axial Gap  C1A14  Front Radar Sensor Beam Axis Not Adjusted  


DESCRIPTION

The driving support ECU assembly uses the millimeter wave radar sensor assembly to detect obstacles in front of the vehicle.

When the vehicle is determined to be driving in a straight line or on a gradual curve based on signals from the yaw rate sensor (airbag ECU assembly), the millimeter wave radar sensor assembly performs self diagnosis to check if the sensor beam axis is deviated from the vehicle movement direction. When the millimeter wave radar sensor assembly beam axis is not adjusted correctly, the driving support ECU assembly detects this, and DTC C1A11 is stored.

After installing a new millimeter wave radar sensor assembly, if sensor beam axis adjustment is not performed, DTC C1A14 is stored.

DTC No. DTC Detection Condition Trouble Area
C1A11 While power switch is on (IG) and after driving at approximately 50 km/h (31 mph) for 10 hours, driving support ECU assembly determines that aim of front millimeter wave radar sensor beam axis is not adjusted correctly or more while the dynamic radar cruise control is operating
·

Millimeter wave radar sensor assembly

·

Driving support ECU assembly


C1A14 Driving at 10 km/h (6 mph) or more while front millimeter wave radar sensor axis adjustment has not been performed or more while the dynamic radar cruise control is operating
·

Millimeter wave radar sensor assembly

·

Driving support ECU assembly



PROCEDURE

1.ADJUST FRONT MILLIMETER WAVE RADAR SENSOR
a.

Adjust the front millimeter wave radar sensor (See page Engine / Hybrid System>CRUISE CONTROL>MILLIMETER WAVE RADAR SENSOR>ADJUSTMENT).



NEXT

2.CHECK FOR DTCs (C1A11 OR C1A14)
2.CHECK FOR DTCs (C1A11 OR C1A14)
a.

Connect the GTS to the DLC3.


b.

Turn the power switch on (IG).



d.

Perform the following to make sure that the DTC detection conditions are met.

HINT:

If the detection conditions are not met, the malfunction cannot be detected.


i.

Drive the vehicle at a speed of between approximately 50 km/h (30 mph) and 170 km/h (105 mph).


ii.

Turn the cruise control system on using the cruise control switch (ON-OFF button).


iii.

Push the cruise control switch to -/SET to begin control of vehicle speed using the cruise control system.



e.

Enter the following menus: Powertrain / Radar Cruise / Trouble Codes.


f.

Check for DTCs.

Result:
Result Proceed to
DTC is not output A
DTC C1A11 or C1A14 is output B




A

END

B

REPLACE DRIVING SUPPORT ECU ASSEMBLY