Home › Engine / Hybrid System › CRUISE CONTROL › DYNAMIC RADAR CRUISE CONTROL SYSTEM › 2016.05–2017.12
RM2070E _51 Engine / Hybrid System _061914 CRUISE CONTROL _0301640 DYNAMIC RADAR CRUISE CONTROL SYSTEM J

CRUISE CONTROL  DYNAMIC RADAR CRUISE CONTROL SYSTEM  Cruise SET Indicator Light Circuit  


DESCRIPTION

·

The driving support ECU turns on the SET indicator light by sending indicator output demand signals to the combination meter sub-assembly using CAN communication.

·

The cruise control SET indicator light illuminates when the cruise control system is controlling vehicle speed.

·

The cruise control SET indicator light circuit uses CAN communication. If the cruise control SET indicator light is not functioning correctly, check for CAN communication DTCs before troubleshooting this circuit.


WIRING DIAGRAM

PROCEDURE

1.PERFORM ACTIVE TEST USING GTS
a.

Connect the GTS to the DLC3.


b.

Turn the power switch on (IG).


c.

Turn the GTS on.


d.

Enter the following menus: Body Electrical / Combination Meter / Active Test.


e.

Check the cruise control SET indicator light by performing the Active Test.

Combination Meter
Tester Display Test Part Control Range Diagnostic Note
Indicat. Lamp SET Cruise control SET indicator light Cruise control SET indicator light ON / OFF -

OK:

The cruise control SET indicator light goes on or goes off.




OK

REPLACE PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG