The transmission control ECU assembly receives a P position switch signal from the power management control ECU and then activates the shift control actuator assembly. At the same time, the transmission control ECU assembly detects the length of time it takes for the parking lock mechanism to switch. The transmission control ECU assembly stores this DTC when this length of time is longer than specified.
| DTC No. | DTC Detection Condition | Trouble Area |
|---|---|---|
| C2301 | A shift control actuator assembly (parking lock motor) internal malfunction (parking lock motor spins freely) is detected for 2 seconds or more. | ·
Auxiliary battery ·
Shift control actuator assembly ·
Hybrid vehicle transaxle assembly ·
Transmission control ECU assembly |
Do not remove/install the auxiliary battery or disconnect the cable from the negative (-) auxiliary battery terminal before instructed.
It may not be possible to clear the following DTCs using the GTS: DTC C2300 (Actuator System Malfunction), C2301 (Shift Changing Time Malfunction), C2303 (Short in Power Source Relay Circuit), C2304 (Open or Short Circuit in U Phase), C2305 (Open or Short Circuit in V Phase), C2306 (Open or Short Circuit in W Phase), C2307 (Power Supply) and C2309 (Open in B+ Circuit). In such cases, disconnect the P CON MAIN fuse and wait for at least 60 seconds to clear the DTCs after the repair.
After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
Connect the GTS to the DLC3.
Turn the power switch on (IG).
Enter the following menus: Body Electrical / Transmission Control / Trouble Codes.
Read the freeze frame data of DTC C2301.
| Result | Proceed to |
|---|---|
| IG (+B) voltage is 9 V or more | A |
| IG (+B) voltage is less than 9 V | B |
Turn the power switch off.
A
B
NEXT
Charge the auxiliary battery.
NEXT
Connect the GTS to the DLC3.
Release the brake pedal and turn the power switch on (IG).
Do not turn the power switch on (READY).
Depress the brake pedal and move the shift lever to select neutral (N).
Enter the following menus: Body Electrical / Transmission Control / Trouble Codes.
Check if DTCs are output.
| Result | Proceed to |
|---|---|
| DTC C2301 is output | A |
| DTC C2301 is not output. | B |
Turn the power switch off.
A
B
OK
NG
OK
NG
NEXT
Inspect the auxiliary battery (See page Power Source / Network>2ZR-FXE (BATTERY / CHARGING)>CHARGING SYSTEM>ON-VEHICLE INSPECTION).
| Result | Proceed to |
|---|---|
| Charge or replace the auxiliary battery. | A |
| The auxiliary battery voltage is normal. | B |
A
B
Charge or replace the auxiliary battery (See page Power Source / Network>2ZR-FXE (BATTERY / CHARGING)>AUXILIARY BATTERY>COMPONENTS).
NEXT