1. PRECAUTION
After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
G3834
2.REMOVE SERVICE PLUG GRIP
51441
3.REMOVE NO. 1 ENGINE UNDER COVER
4.DRAIN COOLANT (for Inverter)
53289A
5.REMOVE RADIATOR SUPPORT OPENING COVER
G9214
6.REMOVE NO. 1 INVERTER BRACKET
82111
7.DISCONNECT ENGINE ROOM MAIN WIRE
G9221
8.REMOVE INVERTER COVER
9.CHECK TERMINAL VOLTAGE
82164
10.DISCONNECT FRAME WIRE
G2148
11.DISCONNECT GENERATOR CABLE
G1148
12.DISCONNECT MOTOR CABLE
82122
13.DISCONNECT NO. 2 ENGINE WIRE
G9221
14.INSTALL INVERTER COVER
82112
15.DISCONNECT NO. 2 ENGINE ROOM WIRE
16.DISCONNECT WATER HOSE
G9200
17.REMOVE INVERTER WITH CONVERTER ASSEMBLY
G92A0A
18.REMOVE INVERTER RESERVE TANK ASSEMBLY
G9219A
19.REMOVE INVERTER TRAY BRACKET
G1148
20.REMOVE MOTOR CABLE
Wear insulated gloves.
Disconnect the 3 clamps.
Remove the 2 bolts and slide the motor cable connector shell back.
Disengage the 2 claws to remove the terminal cap.
Remove the 3 bolts and motor cable from the hybrid vehicle transaxle assembly.