Home › Drivetrain › P410 (HYBRID TRANSMISSION / TRANSAXLE) › HYBRID TRANSAXLE FLUID
RM2070E _52 Drivetrain _061915 P410 HYBRID TRANSMISSION / TRANSAXLE _0301649 HYBRID TRANSAXLE FLUID N

P410 HYBRID TRANSMISSION / TRANSAXLE  HYBRID TRANSAXLE FLUID  ADJUSTMENT  


PROCEDURE

Hide 1.DRAIN HYBRID TRANSAXLE FLUID

a.
C210279E01
0.428,1.309 0.600,1.475 0.172,0.166 10 *1 0.647,1.729 0.818,1.895 0.172,0.166 10 *2 1.111,1.394 0.597,1.394 false 1.345,1.817 0.835,1.817 false

Using a 10 mm hexagon socket wrench, remove the filler plug and gasket.

Text in Illustration
*1 Filler Plug
*2 Drain Plug


b.

Using a 10 mm hexagon socket wrench, remove the drain plug and gasket.


c.

Using a 10 mm hexagon socket wrench, install the drain plug and a new gasket.

Torque:
50 N*m (510 kgf*cm, 37 ft.*lbf)


Hide 2.ADD HYBRID TRANSAXLE FLUID

a.
C233704E04
1.573,0.104 1.677,0.104 1.677,0.104 1.75,1.396 false 0.448,1.49 0.385,1.49 0.385,1.49 0.229,1.24 false 1.365,0.021 1.542,0.198 0.177,0.177 10 false *1 0.469,1.396 0.646,1.573 0.177,0.177 10 false *2

Add transaxle fluid until the fluid level is between 0 and 10 mm (0 to 0.394 in.) from the bottom lip of the filler plug opening.

Text in Illustration
*1 Filler Plug
*2 Filler Nozzle

NOTICE:
·

Stop the vehicle on a level surface.

·

Use Toyota Genuine ATF WS.

·

Be sure to fully insert the filler nozzle into the filler plug opening.

·

Be sure to add fluid slowly. If fluid is added quickly, the fluid may hit internal parts and bounce back, resulting in fluid coming out of the filler plug opening.

·

Be sure to directly check that the transaxle fluid level is within the specified range.

·

Insufficient or excessive amounts of transaxle fluid may damage the hybrid transaxle.



Reference:

3.4 liters (3.6 US qts, 3.0 lmp.qts)



b.

After adding fluid, leave it for 30 seconds so that the fluid surface can become still again, and then check that the fluid level is between 0 and 10 mm (0 to 0.394 in.) from the bottom lip of the filler plug opening. (If the fluid level is too low, return to the Add Hybrid Transaxle Fluid procedure 2.(a).)

NOTICE:

After adding fluid, make sure to check the fluid level.



c.

Using a 10 mm hexagon socket wrench, temporarily install the filler plug and gasket.

HINT:

Because the filler plug will be removed again, the gasket can be reused at this time.