Home › Drivetrain › P410 (HYBRID TRANSMISSION / TRANSAXLE) › HYBRID TRANSAXLE FLUID
RM2070E _52 Drivetrain _061915 P410 HYBRID TRANSMISSION / TRANSAXLE _0301649 HYBRID TRANSAXLE FLUID G

P410 HYBRID TRANSMISSION / TRANSAXLE  HYBRID TRANSAXLE FLUID  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 1.INSPECT HYBRID TRANSAXLE FLUID

a.
C209290E01
1.414,0.094 1.610,0.277 0.196,0.183 10 *1 1.591,0.178 1.71,0.178 1.71,0.178 1.762,1.337 false

Using a 10 mm hexagon socket wrench, remove the filler plug and gasket.

Text in Illustration
*1 Filler Plug


b.

Check that the fluid level is between 0 and 10 mm (0 to 0.394 in.) from the bottom lip of the filler plug opening.

NOTICE:
·

Stop the vehicle on a level surface.

·

Be sure to directly check that the transaxle fluid level is within the specified range.

·

Insufficient or excessive amounts of transaxle fluid may damage the hybrid transaxle.

·

If the fluid was replaced or fluid was added, make sure to recheck the fluid level after driving the vehicle.




c.

Check for leaks if the quantity of transaxle fluid is low. (If there are no fluid leaks but the amount of the fluid is insufficient, add fluid (See page Drivetrain>P410 (HYBRID TRANSMISSION / TRANSAXLE)>HYBRID TRANSAXLE FLUID>ADJUSTMENT).)


d.

Using a 10 mm hexagon socket wrench, install the filler plug with a new gasket.

Torque:
50 N*m (510 kgf*cm, 37 ft.*lbf)