Home › Drivetrain › P410 (HYBRID TRANSMISSION / TRANSAXLE) › INPUT SHAFT OIL SEAL › from 2012.10
RM2070E _52 Drivetrain _061915 P410 HYBRID TRANSMISSION / TRANSAXLE _0301651 INPUT SHAFT OIL SEAL A

P410 HYBRID TRANSMISSION / TRANSAXLE  INPUT SHAFT OIL SEAL  REPLACEMENT  


PROCEDURE

Hide 30900 1.REMOVE HYBRID VEHICLE TRANSAXLE ASSEMBLY

Hide 35710A 2.REMOVE INPUT SHAFT TYPE T OIL SEAL

a.
C209796E01
0.998,0.407 1.158,0.559 0.161,0.152 10 *1 1.774,1.195 1.309,0.489 1.309,0.489 1.178,0.489 false

Using a screwdriver with its tip taped, remove the input shaft type T oil seal.

Text in Illustration
*1 Vinyl Tape

NOTICE:

When removing the input shaft type T oil seal, make sure not to damage the input shaft or hybrid vehicle transaxle housing.



Hide 35710A 3.INSTALL INPUT SHAFT TYPE T OIL SEAL

a.
C209797E01
2.027,2.981 2.322,3.142 0.295,0.161 10 SST 2.206,2.981 2.206,2.825 2.206,2.825 2.077,2.002 false

Coat the lip of a new input shaft type T oil seal with MP grease.


b.

Using SST and a hammer, tap in the input shaft type T oil seal.

SST
09330-50010  

Oil seal installation depth:

1.0 to 1.8 mm (0.0394 to 0.0709 in.)


NOTICE:
·

Ensure that no foreign matter adheres to the input shaft type T oil seal lip.

·

Ensure that the input shaft type T oil seal is not at an angle.




Hide 30900 4.INSTALL HYBRID VEHICLE TRANSAXLE ASSEMBLY