Home › Drivetrain › P410 (HYBRID TRANSMISSION / TRANSAXLE) › SHIFT LEVER › 2014.11–2016.05
RM2070E _52 Drivetrain _061915 P410 HYBRID TRANSMISSION / TRANSAXLE _0301652 SHIFT LEVER A

P410 HYBRID TRANSMISSION / TRANSAXLE  SHIFT LEVER  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:
·

If the shift lock control unit assembly is to be replaced with a new one, it is necessary to clear the learned shift sensor voltage values by disconnecting and reconnecting the cable of the negative (-) auxiliary battery terminal.

·

After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).



Hide 7.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 8.REMOVE SHIFT LEVER KNOB

a.
C302776

Apply protective tape around the shift lock control unit assembly.

NOTICE:

As adhesive residue may fall when removing the shift lever knob, apply protective tape.



b.
C302777

Turn the shift lever knob in the direction of the arrow in the illustration to remove it.


Hide 55431B 10.REMOVE UPPER INSTRUMENT PANEL FINISH PANEL

Hide 58810J 11.REMOVE CONSOLE BOX ASSEMBLY

Hide 12.REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY

Hide 33560 13.REMOVE SHIFT LOCK CONTROL UNIT ASSEMBLY

a.
C241733

Remove the 3 nuts and separate the shift lock control unit assembly.


b.
C241734

Disconnect the 3 connectors and remove the shift lock control unit assembly.