Home › Drivetrain › P410 (HYBRID TRANSMISSION / TRANSAXLE) › SHIFT CONTROL ACTUATOR › from 2012.10
RM2070E _52 Drivetrain _061915 P410 HYBRID TRANSMISSION / TRANSAXLE _0301653 SHIFT CONTROL ACTUATOR A

P410 HYBRID TRANSMISSION / TRANSAXLE  SHIFT CONTROL ACTUATOR  INSTALLATION  


PROCEDURE

Hide 35563 1.INSTALL SHIFT CONTROL ACTUATOR SEAL

NOTICE:

It is not always necessary to replace or remove/install the shift control actuator seal at the same time when replacing the shift control actuator assembly.


HINT:

Remove/install the shift control actuator seal only if oil leaks from the shift control actuator seal or other faults are found when the shift control actuator assembly is removed.


a.
C224532E02
2.158,1.741 2.463,1.906 0.305,0.165 10 SST 2.327,1.32 2.327,1.741 false 1.694,1.982 1.850,2.138 0.156,0.156 10 *a

Using SST and a hammer, tap in a new shift control actuator seal.

SST
09820-00031  

Seal installation depth:

8.5 to 9.8 mm (0.335 to 0.386 in.)


Text in Illustration
*a Seal installation depth


Hide 35580 2.INSTALL SHIFT CONTROL ACTUATOR ASSEMBLY

a.
C236615

Install the shift control actuator assembly with 3 new shift control actuator bolts.

Torque:
9.5 N*m (97 kgf*cm, 84 in.*lbf)


b.
C236614

Install 3 new shift control actuator bolt caps to the shift control actuator bolts.

NOTICE:

Push in each shift control actuator cap firmly until the claw of the shift control actuator bolt cap engages with the control actuator bolt.



c.

Install the bolt and connect the wire harness clamp bracket.

Torque:
29 N*m (296 kgf*cm, 21 ft.*lbf)


d.

Connect the 2 connectors.


Hide 51441 6.INSTALL NO. 1 ENGINE UNDER COVER