Home › Drivetrain › AXLE AND DIFFERENTIAL › FRONT AXLE HUB › from 2016.05
RM2070E _52 Drivetrain _061917 AXLE AND DIFFERENTIAL _0301660 FRONT AXLE HUB A

AXLE AND DIFFERENTIAL  FRONT AXLE HUB  REMOVAL  


CAUTION / NOTICE / HINT

NOTICE:

When the brake pedal is first depressed after replacing the brake pads or pushing back the disc brake piston, DTC C1214 may be output. As there is no malfunction, clear the DTC.


HINT:
·

Use the same procedure for the RH side and LH side.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 3.REMOVE FRONT WHEEL

Hide 89543 5.SEPARATE FRONT SPEED SENSOR

a.
C236451

Remove the bolt, disengage the clamp and separate the front speed sensor wire from the front shock absorber assembly.

NOTICE:

Be sure to separate the front speed sensor from the front shock absorber assembly completely.



b.
C236461

Remove the bolt and separate the front speed sensor from the steering knuckle.

NOTICE:
·

Prevent foreign matter from contacting the sensor tip.

·

Be careful not to damage the front speed sensor.

·

Clean the speed sensor installation hole and the contact surfaces every time the speed sensor is removed.




Hide 47313J 6.SEPARATE FRONT FLEXIBLE HOSE

a.
C236460

Remove the bolt and separate the front flexible hose from the steering knuckle.


Hide 7.SEPARATE FRONT DISC BRAKE CALIPER ASSEMBLY

Hide 43512 8.REMOVE FRONT DISC

Hide 9.SEPARATE TIE ROD END SUB-ASSEMBLY

Hide 48069 10.SEPARATE FRONT LOWER NO. 1 SUSPENSION ARM SUB-ASSEMBLY

a.
C236450

Remove the bolt and 2 nuts, and separate the front lower No. 1 suspension arm sub-assembly from the front lower ball joint assembly.


Hide 43420 11.SEPARATE FRONT DRIVE SHAFT ASSEMBLY

a.
C236455E02
2.844,0.635 3.115,0.635 3.115,0.635 3.115,1.635 false 3,0.958 3.115,0.958 false 3.042,1.635 3.208,1.792 0.167,0.156 10 false *a

Put matchmarks on the front drive shaft assembly and front axle hub sub-assembly.

Text in Illustration
*a Matchmark


b.

Using a plastic hammer, separate the front drive shaft assembly from the front axle assembly. If it is difficult to separate, tap the end of the front drive shaft assembly using a brass bar and a hammer.

NOTICE:

Be careful not to damage the drive shaft boot.



Hide 12.REMOVE FRONT AXLE ASSEMBLY

a.
C236454

Remove the 2 bolts, 2 nuts and front axle assembly from the front shock absorber assembly.

NOTICE:
·

When removing the nuts, keep the bolts from rotating.

·

Be careful not to damage the drive shaft boot.




Hide 43502C 13.REMOVE FRONT AXLE HUB SUB-ASSEMBLY

a.

Secure the front axle assembly between aluminum plates in a vise.

NOTICE:

Do not overtighten the vise.



b.
C130495

Remove the 4 bolts, front axle hub sub-assembly and front disc brake dust cover from the steering knuckle.

NOTICE:

Do not drop the front axle hub sub-assembly.