When the brake pedal is first depressed after replacing the brake pads or pushing back the disc brake piston, DTC C1214 may be output. As there is no malfunction, clear the DTC.
Use the same procedure for the RH side and LH side.
The procedure listed below is for the LH side.
1.REMOVE FRONT AXLE ASSEMBLY
43340A
2.REMOVE FRONT LOWER BALL JOINT ASSEMBLY
43212
3.REMOVE STEERING KNUCKLE
Secure the front axle assembly between aluminum plates in a vise.
Do not overtighten the vise.
Remove the 4 bolts, front axle hub sub-assembly and front disc brake dust cover from the steering knuckle.
Do not drop the front axle hub sub-assembly.