Home › Drivetrain › AXLE AND DIFFERENTIAL › REAR AXLE HUB BOLT
RM2070E _52 Drivetrain _061917 AXLE AND DIFFERENTIAL _0301662 REAR AXLE HUB BOLT A

AXLE AND DIFFERENTIAL  REAR AXLE HUB BOLT  REPLACEMENT  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH side and LH side.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 46555 1.REMOVE BRAKE SHOE HOLD DOWN SPRING (for Front Side)

Hide 42312E 2.REMOVE REAR AXLE HUB BOLT

a.
C236243

Pull the No. 1 parking brake shoe assembly towards the front of the vehicle by hand as shown in the illustration.


b.
C236491E03
2.146,0.906 2.146,0.719 2.146,0.719 2.719,0.719 true 2.479,1.021 2.479,0.719 true 1.656,1.281 1.365,1.281 true 2.719,0.646 2.875,0.792 0.156,0.146 10 false *1 1.031,1.198 1.333,1.354 0.302,0.156 10 true SST

Temporarily install 2 service nuts to the rear axle hub bolts as shown in the illustration.

Text in Illustration
*1 Service Nut

Recommended service nut:

Thread diameter: 12.0 mm (0.472 in.)

Thread pitch: 1.5 mm (0.0591 in.)


NOTICE:

Install the service nuts to prevent damage to the rear axle hub bolts.



c.

Using SST and a screwdriver or an equivalent tool to hold the rear axle hub and bearing assembly, remove the rear axle hub bolt.

SST
09611-12010  

NOTICE:

Do not damage the threads of the rear axle hub bolts.



Hide 42312E 3.INSTALL REAR AXLE HUB BOLT

a.
C236492E02
0.978,0.039 1.127,0.201 0.149,0.163 10 *1 0.206,0.051 0.355,0.214 0.149,0.163 10 *2 0.793,0.608 0.793,0.137 0.793,0.137 0.979,0.137 false 0.529,0.481 0.529,0.139 0.529,0.139 0.372,0.139 false

Temporarily install a new rear axle hub bolt to the rear axle hub and bearing assembly.

Text in Illustration
*1 Service Nut
*2 Washer


b.

Install a washer and service nut to the new rear axle hub bolt as shown in the illustration.

Recommended service nut:

Thread diameter: 12.0 mm (0.472 in.)

Thread pitch: 1.5 mm (0.0591 in.)


HINT:

Recommended washer thickness is 5 mm (0.197 in.) or more.



c.

Using a screwdriver or an equivalent tool to hold the rear axle hub and bearing assembly, install the rear axle hub bolt by tightening the service nut.

NOTICE:
·

Install the service nuts to prevent damage to the rear axle hub bolts.

·

Do not damage the threads of the rear axle hub bolts.




d.

Remove the 3 service nuts and washer from the 3 rear axle hub bolts.


e.

Install the No. 1 parking brake shoe assembly.


Hide 46555 4.INSTALL BRAKE SHOE HOLD DOWN SPRING (for Front Side)