Home › Drivetrain › AXLE AND DIFFERENTIAL › REAR AXLE HUB › from 2016.05
RM2070E _52 Drivetrain _061917 AXLE AND DIFFERENTIAL _0301663 REAR AXLE HUB A

AXLE AND DIFFERENTIAL  REAR AXLE HUB  REMOVAL  


CAUTION / NOTICE / HINT

NOTICE:

When the brake pedal is first depressed after replacing the brake pads or pushing back the disc brake piston, DTC C1214 may be output. As there is no malfunction, clear the DTC.


HINT:
·

Use the same procedure for the RH side and LH side.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 3.REMOVE REAR WHEEL

Hide 5.SEPARATE REAR DISC BRAKE CALIPER ASSEMBLY

Hide 42491 6.REMOVE PARKING BRAKE SHOE ADJUSTING HOLE PLUG

Hide 42431 7.REMOVE REAR DISC

Hide 42450B 8.REMOVE REAR AXLE HUB AND BEARING ASSEMBLY

a.
C236493

Remove the 4 bolts, rear axle hub and bearing assembly from the rear axle beam assembly.