Home › Drivetrain › AXLE AND DIFFERENTIAL › REAR AXLE HUB › from 2016.05
RM2070E _52 Drivetrain _061917 AXLE AND DIFFERENTIAL _0301663 REAR AXLE HUB G

AXLE AND DIFFERENTIAL  REAR AXLE HUB  ON-VEHICLE INSPECTION  


CAUTION / NOTICE / HINT

NOTICE:

When the brake pedal is first depressed after replacing the brake pads or pushing back the disc brake piston, DTC C1214 may be output. As there is no malfunction, clear the DTC.


HINT:
·

Use the same procedure for the RH side and LH side.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 3.REMOVE REAR WHEEL

Hide 4.SEPARATE REAR DISC BRAKE CALIPER ASSEMBLY

a.

Remove the 2 bolts, and separate the rear disc brake caliper assembly.

NOTICE:

Use wire or an equivalent tool to keep the brake caliper from hanging down by the flexible hose.



Hide 42491 5.REMOVE PARKING BRAKE SHOE ADJUSTING HOLE PLUG

Hide 42431 6.REMOVE REAR DISC

Hide 7.INSPECT REAR AXLE HUB BEARING LOOSENESS

a.
C236489

Using a dial indicator, check for looseness near the center of the rear axle hub.

Maximum looseness:

0.05 mm (0.00196 in.)


NOTICE:
·

Ensure that the dial indicator is set perpendicular to the measurement surface.

·

Keep the magnet of the dial indicator away from the rear axle hub and bearing (rear speed sensor).



If the looseness exceeds the maximum, replace the rear axle hub and bearing assembly.


Hide 8.INSPECT REAR AXLE HUB RUNOUT

a.
C236490

Using a dial indicator, check for runout on the surface of the rear axle hub outside the rear axle hub bolts.

Maximum runout:

0.05 mm (0.00196 in.)


NOTICE:
·

Ensure that the dial indicator is set perpendicular to the measurement surface.

·

Make sure to set the tip of the dial indicator towards the outside of the rear axle hub bolts.

·

Keep the magnet of the dial indicator away from the rear axle hub and bearing (rear speed sensor).



If the runout exceeds the maximum, replace the rear axle hub and bearing assembly.


Hide 42431 9.INSTALL REAR DISC

Hide 42491 10.INSTALL PARKING BRAKE SHOE ADJUSTING HOLE PLUG

Hide 11.INSTALL REAR DISC BRAKE CALIPER ASSEMBLY

a.

Install the rear disc brake caliper assembly with the 2 bolts.

Torque:
72 N*m (734 kgf*cm, 53 ft.*lbf)


Hide 12.CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

a.

Connect the cable to the negative (-) auxiliary battery terminal (See page Power Source / Network>2ZR-FXE (BATTERY / CHARGING)>AUXILIARY BATTERY>INSTALLATION).


b.

Connect the reservoir level switch connector.



Hide 13.ADJUST PARKING BRAKE

Hide 14.INSTALL REAR WHEEL

Torque:
103 N*m (1050 kgf*cm, 76 ft.*lbf)