Use the same procedure for the RH side and LH side.
The procedure listed below is for the LH side.
1.REMOVE FRONT WHEEL
2.REMOVE WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY
55736D
3.REMOVE COWL BODY MOUNTING REINFORCEMENT LH (for LHD)
55735C
4.REMOVE COWL BODY MOUNTING REINFORCEMENT RH (for RHD)
55701J
5.REMOVE OUTER COWL TOP PANEL SUB-ASSEMBLY (for LHD)
55701J
6.REMOVE OUTER COWL TOP PANEL SUB-ASSEMBLY (for RHD)
48810
7.SEPARATE FRONT STABILIZER LINK ASSEMBLY
Remove the nut and separate the front stabilizer link assembly from the front shock absorber assembly.
If the ball joint turns together with the nut, use a hexagon wrench to hold the stud bolt.
89543
8.SEPARATE FRONT SPEED SENSOR
Remove the bolt, disengage the clamp and separate the front speed sensor and front flexible hose from the front shock absorber assembly.
Be sure to separate the front speed sensor from the front shock absorber assembly completely.
48684B
9.REMOVE FRONT SUSPENSION SUPPORT DUST COVER
Remove the front suspension support dust cover.
10.REMOVE FRONT SHOCK ABSORBER WITH COIL SPRING
Loosen the front support to front shock absorber nut.
Do not remove the front support to front shock absorber nut.
Loosen the front support to front shock absorber nut only when the front shock absorber with coil spring needs to be disassembled.
Support the front lower No. 1 suspension arm sub-assembly using a jack and wooden block.
| *1 | Wooden Block |
| *2 | Jack |
Remove the 2 bolts and 2 nuts, and separate the front shock absorber with coil spring (lower side) from the steering knuckle.
When removing the nuts, keep the bolts from rotating.
Remove the 3 nuts and front shock absorber with coil spring.
Make sure that the front speed sensor is completely separated from the front shock absorber with coil spring.
48609E
11.REMOVE FRONT SUPPORT TO FRONT SHOCK ABSORBER NUT
Secure SST in a vise.
Attach the arm of SST to the diameter of the front coil spring.
| *a | Correct |
| *b | Incorrect |
Make sure that the front coil spring is installed so that the distance between the upper and lower hooks of SST is at the maximum.
Make sure that the claws of the hooks are securely attached.
Using SST, compress the front coil spring.
If the front coil spring bends during the compression, immediately stop the compression and reinstall SST.
Do not compress the spring until the coil springs contact each other.
Do not use an impact wrench. It will damage SST.
Confirm that the front coil spring becomes free and remove the front support to front shock absorber nut.
Do not remove the front support to front shock absorber nut when the front coil spring is not free.
Remove the collar.
48609
12.REMOVE FRONT SUSPENSION SUPPORT SUB-ASSEMBLY
48619A
13.REMOVE STRUT MOUNTING BEARING
48045A
14.REMOVE FRONT SPRING SEAT SUB-ASSEMBLY WITH INSULATOR
Disengage the front spring seat sub-assembly with insulator from the claws of the front shock absorber assembly.
| *1 | Front Spring Seat Sub-assembly with Insulator |
| *a | Claw |
Remove the front spring seat sub-assembly with insulator from the front shock absorber assembly.
48132
15.REMOVE FRONT COIL SPRING
48331C
16.REMOVE FRONT SPRING BUMPER
48158C
17.REMOVE FRONT LOWER COIL SPRING INSULATOR
48520
18.REMOVE FRONT SHOCK ABSORBER ASSEMBLY