Home › Suspension › FRONT SUSPENSION › FRONT LOWER BALL JOINT
RM2070E _53 Suspension _061919 FRONT SUSPENSION _0301669 FRONT LOWER BALL JOINT A

FRONT SUSPENSION  FRONT LOWER BALL JOINT  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH side and LH side.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 43340A 1.INSTALL FRONT LOWER BALL JOINT ASSEMBLY

a.

Secure the front axle assembly in a vise using aluminum plates.

NOTICE:

When using a vise, do not overtighten it.



b.

Install the front lower ball joint assembly to the front axle assembly with the nut.

Torque:
133 N*m (1356 kgf*cm, 98 ft.*lbf)

NOTICE:

Prevent oil from adhering to the threaded and tapered parts.



c.

Install a new cotter pin.

NOTICE:

Further tighten the nut up to 60° if the holes for the cotter pin are not aligned.



Hide 2.INSTALL FRONT AXLE ASSEMBLY