Home › Suspension › REAR SUSPENSION › REAR SHOCK ABSORBER
RM2070E _53 Suspension _061920 REAR SUSPENSION _0301673 REAR SHOCK ABSORBER A

REAR SUSPENSION  REAR SHOCK ABSORBER  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH side and LH side.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 64715C 1.REMOVE DECK SIDE TRIM COVER

a.
C236494

Disengage the 6 claws and remove the deck side trim cover.


Hide 2.REMOVE REAR WHEEL

Hide 89407A 3.SEPARATE REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY (w/ Height Control Sensor)

Hide 48530B 4.REMOVE REAR NO. 1 SHOCK ABSORBER CUSHION WASHER

a.
C236499E01
1.084,1.496 1.251,1.646 0.167,0.150 10 *1 1.093,1.801 1.260,1.951 0.167,0.150 10 *2 1.885,1.579 1.272,1.579 false 2.097,1.889 1.289,1.889 false

Support the spring seat of the rear axle beam assembly using a jack and wooden block.

Text in Illustration
*1 Wooden Block
*2 Jack

CAUTION:

Do not jack up the rear axle beam assembly too high as the vehicle may fall.


NOTICE:

Keep supporting the rear axle beam assembly with a jack until the installation of the rear shock absorber assembly is completed.


HINT:

Support the rear shock absorber at a position where it compresses by approximately 20 to 30 mm (0.787 to 1.18 in.).



b.
C236495

Using a hexagon wrench, secure the rear shock absorber rod and remove the lock nut.

NOTICE:

Securely insert the hexagon wrench to the rear shock absorber rod to prevent damage to the rear shock absorber assembly when removing the nut.



c.
C236496

Remove the rear No. 1 shock absorber cushion washer.


Hide 48755 5.REMOVE REAR SUSPENSION SUPPORT

a.

Remove the rear suspension support.


Hide 48540 6.REMOVE REAR SHOCK ABSORBER ASSEMBLY

a.
C236519

Remove the bolt while holding the nut and remove the rear shock absorber assembly.

NOTICE:

Since the stopper nut is used, turn the bolt.



Hide 48341B 7.REMOVE REAR NO. 1 SPRING BUMPER

a.
C184836

Remove the rear No. 1 spring bumper from the rear shock absorber assembly.