Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › FRONT SPEED SENSOR › from 2016.05
RM2070E _54 Brake _061923 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0301684 FRONT SPEED SENSOR A

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  FRONT SPEED SENSOR  REMOVAL  


CAUTION / NOTICE / HINT

NOTICE:

While the auxiliary battery is connected, even if the power switch is off, the brake control system activates when the brake pedal is depressed or any door courtesy switch is turned on. Therefore, when servicing brake system components, do not depress the brake pedal or open/close the doors while the auxiliary battery is connected.


HINT:
·

Use the same procedure for the LH side and RH side.

·

The following procedure is for the LH side.

·

If the sensor rotor needs to be replaced, replace the front axle hub sub-assembly.



PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

Hide 53876A 3.REMOVE FRONT FENDER LINER

HINT:

Use the same procedure for the LH side and RH side (See page Vehicle Exterior>WIPER / WASHER>WASHER MOTOR(for Front Side)>REMOVAL).


Hide 89543 4.REMOVE FRONT SPEED SENSOR

a.
C236066

Disconnect the front speed sensor connector and disengage the 2 clamps.


b.
C211459E01
2.1,1.17 2.267,1.338 0.167,0.167 10 *1 2.085,1.259 1.965,1.259 false

Remove the bolt and separate the No. 2 sensor clamp from the body.

Text in Illustration
*1 No. 2 Sensor Clamp


c.
C239201E01
1.974,0.353 2.132,0.495 0.158,0.143 10 *1 2.214,1.673 2.372,1.815 0.158,0.143 10 *2 1.818,0.666 1.818,0.436 1.818,0.436 1.974,0.436 false 2.009,1.766 2.214,1.766 false

Remove the bolt, No. 1 sensor clamp and front flexible hose together from the front shock absorber assembly.

Text in Illustration
*1 No. 1 Sensor Clamp
*2 Front Flexible Hose


d.
C239202

Disengage the clamp from the front shock absorber assembly.


e.

Remove the bolt and front speed sensor from the steering knuckle.

NOTICE:
·

Prevent foreign matter from attaching to the front speed sensor tip.

·

Clean the front speed sensor installation hole and the contact surfaces every time the front speed sensor is removed.