Home › Vehicle Exterior › WIPER / WASHER › WASHER MOTOR(for Front Side) › from 2014.11
RM2070E _59 Vehicle Exterior _061952 WIPER / WASHER _0301897 WASHER MOTOR(for Front Side) A

WIPER / WASHER  WASHER MOTOR(for Front Side)  REMOVAL  


PROCEDURE

Hide 1.REMOVE FRONT WHEEL RH

Hide 75850A 2.REMOVE BODY ROCKER PANEL MOULDING ASSEMBLY RH

HINT:

Use the same procedure as for the LH side (See page Vehicle Exterior>EXTERIOR PANELS / TRIM>ROCKER PANEL MOULDING>REMOVAL).


Hide 53875A 3.REMOVE FRONT FENDER LINER RH

a.
E306318

Remove the 3 screws.


b.
E306319

Remove the 10 clips.


c.
E306320

Using a clip remover, remove the grommet and front fender liner RH.

HINT:

The grommet will need to be replaced with a new one as it will break when it is removed.



Hide 4.DRAIN WASHER FLUID

a.
E306321

Disconnect the washer hose from the windshield washer motor and pump assembly, and drain the washer fluid.

HINT:

Use a container to collect the washer fluid.



Hide 85310 5.REMOVE WINDSHIELD WASHER MOTOR AND PUMP ASSEMBLY

a.
E306403

Disconnect the connector.


b.

Remove the windshield washer motor and pump assembly.