Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › REAR SPEED SENSOR
RM2070E _54 Brake _061923 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0301685 REAR SPEED SENSOR A

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  REAR SPEED SENSOR  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the LH side and RH side.

·

The following procedure is for the LH side.

·

If the sensor rotor needs to be replaced, replace the rear axle hub and bearing assembly.

·

The rear speed sensor is a component of the rear axle hub and bearing assembly. If the rear speed sensor malfunctions, replace the rear axle hub and bearing assembly.



PROCEDURE

Hide 42450B 1.INSTALL REAR AXLE HUB AND BEARING ASSEMBLY

a.

Install the rear axle hub and bearing assembly (See page Drivetrain>AXLE AND DIFFERENTIAL>REAR AXLE HUB>INSTALLATION).

HINT:
·

If the sensor rotor needs to be replaced, replace the rear axle hub and bearing assembly.

·

The rear speed sensor is a component of the rear axle hub and bearing assembly. If the rear speed sensor malfunctions, replace the rear axle hub and bearing assembly.




Hide 42431 4.INSTALL REAR DISC

Hide 42491 5.INSTALL PARKING BRAKE SHOE ADJUSTING HOLE PLUG

Hide 89516D 7.CONNECT SKID CONTROL SENSOR WIRE

a.

Connect the skid control sensor wire connector to the rear speed sensor.


Hide 8.CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

a.

Connect the cable to the negative (-) auxiliary battery terminal (See page Power Source / Network>2ZR-FXE (BATTERY / CHARGING)>AUXILIARY BATTERY>INSTALLATION).


b.

Connect the reservoir level switch connector.



Hide 9.ADJUST PARKING BRAKE

Hide 10.INSTALL REAR WHEEL

Torque:
103 N*m (1050 kgf*cm, 76 ft.*lbf)