If both left and right hoses are disconnected at the same time, be sure to place identification marks indicating the position on each side.
Use the same procedure for the LH side and RH side.
The following procedure is for the LH side.
1. PRECAUTION
After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
2. DISABLE BRAKE CONTROL
3.REMOVE FRONT WHEEL
4.DRAIN BRAKE FLUID
If brake fluid leaks onto any painted surface, immediately wash it off.
47313J
5.REMOVE FRONT FLEXIBLE HOSE
Remove the union bolt and gasket, and separate the front flexible hose from the disc brake cylinder assembly.
Using a union nut wrench, disconnect the brake line while holding the front flexible hose with a wrench.
Do not kink or damage the brake line.
Do not allow any foreign matter such as dirt or dust to enter the brake line from the clip or bracket.
Remove the clip.
| *1 | Clip |
Remove the bolt (A) and separate the front speed sensor bracket from the absorber bracket.
| *1 | Front Speed Sensor Bracket |
| *2 | Front Flexible Hose Bracket |
Remove the bolt (B) and front flexible hose from the steering knuckle.