1.REMOVE AIR CONDITIONING UNIT ASSEMBLY
89183A
2.REMOVE YAW RATE AND ACCELERATION SENSOR
46441
3.LOOSEN ADJUSTING NUT
Remove the lock nut and loosen the adjusting nut.
| *1 | Lock Nut |
| *2 | Adjusting Nut |
46302
4.SEPARATE NO. 1 PARKING BRAKE PULL ROD SUB-ASSEMBLY
Separate the No. 1 parking brake pull rod sub-assembly from the parking brake control pedal assembly as shown in the illustration.
| *a | Turn |
| *b | Hold |
46200
5.REMOVE PARKING BRAKE CONTROL PEDAL ASSEMBLY
Remove the 4 bolts and nut, and separate the No. 1 parking brake cable assembly.
Disengage the 2 wire harness clamps.
Remove the No. 1 parking brake cable assembly from the clamp.
Disconnect the parking brake switch connector.
Disengage the wire harness clamp.
Remove the bolt, 2 nuts and parking brake control pedal assembly.