Home › Steering › POWER ASSIST SYSTEMS › POWER STEERING SYSTEM › 2012.03–2016.05
RM2070E _55 Steering _061928 POWER ASSIST SYSTEMS _0301712 POWER STEERING SYSTEM C

POWER ASSIST SYSTEMS  POWER STEERING SYSTEM  C1521/24  Short in Motor Circuit  C1531/25  ECU Malfunction  C1532/25  ECU Malfunction  C1533/25  Temperature Sensor Circuit is Low or High  C1534/25  EEPROM Malfunction  


DESCRIPTION

If the power steering ECU assembly stores these DTCs, it will shut off the motor relay circuit (built into the power steering ECU assembly) and stop power assist. However, power assist continues if DTC C1533/25 or C1534/25 is output.

DTC No. DTC Detection Condition Trouble Area
C1521/24 Motor overcurrent Power steering ECU assembly
C1531/25 ECU internal malfunction (CPU malfunction)
C1532/25 ECU internal malfunction (Peripheral circuit malfunction)
C1533/25 ECU internal malfunction (Substrate temperature sensor malfunction)
C1534/25 ECU internal malfunction (EEPROM error)

CAUTION / NOTICE / HINT

NOTICE:

If the power steering ECU assembly has been replaced with a new one, perform assist map writing and rotation angle sensor value initialization torque sensor zero point calibration after performing the initialization of the torque sensor zero point value (See page Steering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>CALIBRATION).


PROCEDURE

1.CHECK FOR DTC


Result:
Result Proceed to
DTCs (except C1521/24, C1531/25, C1532/25, C1533/25, C1534/25 DTC) are not output A
DTCs (except C1521/24, C1531/25, C1532/25, C1533/25, C1534/25 DTC) are output B



A

REPLACE POWER STEERING ECU ASSEMBLY

B