Home › Steering › POWER ASSIST SYSTEMS › POWER STEERING SYSTEM › 2012.03–2014.11
RM2070E _55 Steering _061928 POWER ASSIST SYSTEMS _0301712 POWER STEERING SYSTEM C

POWER ASSIST SYSTEMS  POWER STEERING SYSTEM  C1582/26  Assist Map Number Mismatch  


DESCRIPTION

When an incorrect power management control ECU is installed after the assist map has been recorded in the power steering ECU assembly, then DTC C1582/26 is stored because the data does not match the vehicle specifications.

DTC No. DTC Detection Condition Trouble Area
C1582/26 Assist map number mismatch
·

Power steering ECU assembly

·

CAN communication system

·

Power management control ECU



CAUTION / NOTICE / HINT

NOTICE:

If the power steering ECU assembly has been replaced with a new one, perform assist map writing and rotation angle sensor value initialization torque sensor zero point calibration after performing the initialization of the torque sensor zero point value (See page Steering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>CALIBRATION).


PROCEDURE

1.CHECK FOR DTC (CAN COMMUNICATION SYSTEM)
a.

Using the GTS, check for DTCs and confirm that there are no problems in the CAN communication system (See page Power Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM (w/o Central Gateway ECU)>DIAGNOSIS SYSTEM).

OK:

DTC is not output.




OK

2.CHECK POWER MANAGEMENT CONTROL ECU

NG

2.CHECK POWER MANAGEMENT CONTROL ECU
a.

Check if a power management control ECU that complies with the vehicle specifications is installed.

OK:

A power management control ECU that complies with vehicle specifications is installed.




OK

REPLACE POWER STEERING ECU ASSEMBLY

NG