86140A
1.INSTALL RADIO AND DISPLAY RECEIVER ASSEMBLY
86211J
2.INSTALL NO. 1 RADIO RECEIVER BRACKET
Install the No. 1 radio receiver bracket with the 4 screws.
86212C
3.INSTALL NO. 2 RADIO RECEIVER BRACKET
Use the same procedure as for the No. 1 radio receiver bracket.
4.INSTALL RADIO AND DISPLAY RECEIVER ASSEMBLY WITH BRACKET
Connect each connector.
Engage the 2 guides and 5 claws.
Install the radio and display receiver assembly with bracket with the 4 bolts.
5.INSTALL CENTER INSTRUMENT PANEL REGISTER ASSEMBLY
55440D
6.INSTALL INSTRUMENT PANEL BOX ASSEMBLY
7.INSTALL INTEGRATION CONTROL AND PANEL
8.CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION)
64995
9.INSTALL DECK FLOOR BOX RH
64993
10.INSTALL REAR DECK FLOOR BOX
58411A
11.INSTALL NO. 1 DECK BOARD
58412A
12.INSTALL NO. 2 DECK BOARD
58410B
13.INSTALL DECK BOARD ASSEMBLY